I have some zipwire from best buy, but it is unterminated. The exposure only works with bananas. Is there any way to test it with the unterminated wire?
thanks -- Marty
thanks -- Marty
Advice on RFI with a new integrated amp
Marty, If the DNM speaker cable is acting as an antenna , in your situation, parallel wire (Zip cord) will more than likely do the same thing. Read page 11 You will need to use twisted pair cable. You might check Radio Shack for some cheap cable and banana plugs for testing. If it solves your problem then you can buy something better. Jim |
Glad to hear it, Marty. But I'm truly surprised, given all the reasons I cited as to why it was unlikely to be due to speaker cable pickup. So somehow what was being picked up in those cables was making its way back to the front end of the integrated amp, where it could be affected by the volume control and source selection, amplified, and detected/rectified somehow (I still doubt that it was an fm signal, for which no detection mechanism is present). Jim, I owe you a beer! Regards, -- Al |