Graham Phantom damping fluid level.

Sirspeedy, what is your current fluid level? If you could say where it is in relationship to the machined square on the bearing cap that would help. Glad you are having fun with your new tonearm.

Frank,currently I have the fluid level just touching the very bottom of the squared bearing block.Just overlapping it,by a tiny margin.I only have "one" lengthly listening session with the arm,so I may very well add a touch more fluid this week.I have the (old?)blue fluid,which seems to be quite good.One thing different from my friend's Phantom.....the bearing on my arm is much pointier,and it does NOT slip out of alignment,like my pal's does.Not a big deal,but a better modification.
Fortunately I have a very good idea how my specific ref set-up LP's should sound,and this dramatically cuts down on the "voicing" time.The set up time was a pain,though kinda fun,but because I want to max out my Orpheus,I am being fanatical about all parameters.I spent about 6-7 hrs on overall set-up,and am literally exhausted.
Also,because of the general excellent feedback, from all other posters here,and their comittment to exactitude,I am attempting to go a bit beyond what I normally think is very good sound!....I have a Wally set-up tool on the way,to verify what I have done with the acceptable(not perfect)Graham jig!
Best.

I always prove alignment with my own protrator (designed on my CAD system) and I am actually very impressed with the outcome of alignment using the Graham jig. As a machinist, I am a stickler for ultimate accuracy, hence all the questions I ask regarding fluid level.

If there is a downside to the Graham arm design, I would say the azimuth alignment/adjustment could be improved upon. I find it extremely difficult to install the armwand and repeat azimuth with any degree of accuracy. Bob obviously designed in the ability to adjust azimuth by moving the magnet up or down but I find it perplexing that the armwand has several degrees of play where it locates on the actual pins where the wand meets the base. If it was my design I would have implicated 2 pins to register the wand postively with the base for exact alignment to make swapping wands a "walk in the park" As it is now, I dread removing the armwand.

Hmm,Frank I don't see/feel that particular wand problem.My jig has more play in it than my friend's,who lives 40 minutes away.I'm willing to bet that I am almost spot on,but want to be sure,hence the WAlly.
Best.

It's definitely a good idea to verify alignment with a good protractor but you mentioned that your armboard was drilled 0.100" out of spec. so how will you fix that?....if that is indeed the case.