Graham Phantom damping fluid level.

You need the VTA fairly negative as a rule of thumb on Koetsu. The back of the cartridge should be level. If you know Koetsu this indicates the front of the cartridge being tilted up or a negative VTA. This can only be achieved w. a spacer. The benefit of this approach is that you can increase the effective mass of the arm and the Koetsu (order a spacer in brass is ideal) will sound much better. I know, everyone is going on about damping. But that is fine tuning after everything else is correct. Get the resonant frequency below 12 Hz. I doubt anyone w, a Graham has done so if extra mass was not added. Once you get that done you will hear dynamics and bass. Until then, it will be much more congested.

I have found(even on the Phantom)that whenever I adjust fluid level,the VTA AND VTF should be atended to as well.It's a sort of Rubics Cube combo,but not really hard to do.You MUST become very hands on,and play around alot!
Best.

Has anyone tried contacting Graham Engineering? Last I called, the voicebox was full and email has been unresponsive. When I received my arm, it was SME mount and I wanted a template. I had to resort to buying a new armboard from TW for my Raven One.

Frank i found that if i lowered the tracking force just above the distortion point i get great highs. Then i adjust the damping level and it all seems to fall into place, great clean top end and monsterous bass.If i go to low on the damping fluid it becomes thin sounding .

Sirspeedy- i left Graham a message about the cartridge spacer early last week and i have received no response so far. I hear he is having some troubles hope things work out ok for him.