Scheu table question from past posting - images

On my table the inner bearing has a small o-ring (much smaller than the one pictured) that fits into a groove under it so when you screw it on it makes contact with the oil reservoir. In your picture that shows the inner bearing screwed on you would be able to faintly see the o-ring. It would hardly protrude out from under the inner bearing.

My outer bearing has an attached black piece (can't recall if it's rubber or plastic) permanently fitted to it. Your o-ring (which may or may not be meant for the outer bearing) seems to take up a lot more space within the reservoir.

It's quite possible the design has changed, but then that doesn't account for the manual's instructions (maybe you have an older manual that was not updated). How is the fit of the o-ring on the outer bearing? Is it a natural fit, in other words did it appear to be meant for the outer bearing, or did you have to fiddle with it to make it fit? Have you talked to Tom Hills at Hudson Audio or any of the other Scheu experts out there about this?

Take a look at the assembly instructions here:

http://www.soundscapehifi.com/scheu-premier-setup.htm

It shows you where the different o-rings are used.

---Gary

Thanks Gary,

I did look at that and thats why I have questions.
The O Ring I have does not fit under the inner bearing but just over the outer bearing only.

Looking at that instruction there, the inner bearing hovers over the O ring and once its placed, you can not even see it. The the outer bearing goes over all of that.
Makes more sense but not with what I have.