2. analog
  3. 1290826016

Try a different turntable?

Ever since getting into audio, I've owned a VPI turntable (HW19 upgraded with heavier platter, SAMA, JMW arm). It sounds good, without question. But I've been curious about other TTs that (folks say) come from a different design philosophy--Linn and Rega are often mentioned in this connection.

For the next two years, I am in the fortunate position of having two stereo systems; then I will retire and consolidate into one house and one system. I've set up my second system except for vinyl. What 'table/arm combos would folks recommend as an alternative to the VPI (at about the same price)? Ideally also it would be a tad smaller than the big VPIs since I have less space in the retirement home.

I listen to a little of everything, but like acoustic music (classical, folk, jazz) best, and am looking for a setup that will really connect with the music.

Thanks for suggestions!
magister
mickeyf
153 posts
 
Sure, in both cases the motor is more or less solidly coupled directly to the platter either through the DD shaft or through the quite solid coupling wheel. In belt drive it is decoupled by the belt., why would a properly designed belt drive have speed stability issues??? where does this myth arise from?
canam
21 posts
 
Why do you call speed stability problems with belt drives a myth? Since there is no direct coupling between the motor and platter the motor/belt cannot respond to changes in the drag force from the stylus - with more flexible belts this gets worse. And I have heard this difference directly. Maybe there are belt drive TT's I haven't heard that are better, but I suspect at much higher costs than the rebuilt idlers. And there is anecdotal evidence to suggest that properly plinthed idler TT's are "world beaters" with some very expensive tables losing shootouts to the idlers. But, as I said earlier, my primary evidence is what I heard directly in my system.
mickeyf
153 posts
 
Are you telling me the drag force of a delicate stylus at say 2 grams would alter the speed of a moving disc at 4000 gms or 10,000 grams (roughly the weight of my platter). I would bet the friction required to do that would tear the tip right off the stylus.
Do you really believe this?
geoch's avatar
geoch
354 posts
 
I can clearly hear this happening on my 24 kg platter !
canam
21 posts
 
Re drag force of stylus - When I first read of this phenomenon, I didn't believe it would make enough of a difference to hear, but it's the only plausible explanation for what I am hearing in my system between the idler and the belt drive table I used to have. It was so clear to me, I was stunned by the difference - and I'm not an experienced listener.
More to discover