Rega rp8 vs Project extension 10

No experience with either table, but be aware that some Rega tables are known to run fast. Make sure the one you heard is maintaining correct speed, as otherwise its "speedy dynamics" may in fact be a distortion of the music.

Beyond that, comparing the sonics of two fairly evenly matched rigs is a challenge. It sounds like the rigs you heard were located in different rooms, attached to different systems, set up by different people, perhaps with different cartridges and were playing different records. With so many variables, even highly trained ears might be unable to tell which sonic differences were due to the rigs themselves vs. the other factors.

Best hope is if people have compared them side by side in the same system, with the same cartridge, playing the same record.

Hope you get some useful inputs. Good luck!

Not sure what other components you have but if equally old, you could look at saving a little on the rp8 with a rp6/ Clearaudio Concept and getting better amplification. While I am a spend as much on the source man, some older setups have awful old receivers and flabby speakers.

I really like my RP6 setup (see system link). The at-33ptg/ll, groovetracer ref sub platter and upgraded RCA connectors with furutech 126g made some very nice changes.

Well for components I have a cary slp-98p preamp with phono for mm cartridges. And for a power amp I have a cary cad120s with kt-120tubes and totem forest speakers. Which is an a great system with my old jvc and drives the speakers with ease.
So I demoed both with an ortofon black cartridge mm and both with a all tube integrated amp. But was planing on getting ether one the ortofon black to work with my existing preamp. Which people tell me its a great cartridge. I also have a large majority of old used vinyl too to use with a new turntable to keep in mind.
I also used a good selection to demo, my 3 albums Stevie ray "The Sky is crying", Daft Punk "Random Access " and Little Feat "Waiting for Columbus Live" Reissue.

I use a SLP-98P F-1, though I'm currently running my TTs through a Zesto phono stage.

The Cary's phono stage should work great with the Ortofon Black. I also had very good results running a Denon DL-103r through a Bob's Devices SUT into the MM section of the Cary. I felt that the Cary's MM phono section was comparable to that in the MiniMax, perhaps with a bit less richness in the mids.

I think you should be fine with your cartridge choice and either of the TTs.