Best bi-wire speaker cables under $1000


I have a Bryston 4BST amp, Bryston BP 25 preamp and I am looking to upgrade my Monster speaker cable. I do not even know where to start these days. My main listening is vocals, specifically female and jazz. Any ideas out there in the Audio world? Your input is greatly appreciated.

Bryan Hodges
bryanhod
Sean,

Yes im getting an unexpected dip (its actually at 800hz)
my in-room response is +/- 3db worst case.. above 80hz except for 2 spots one at 800hz and one at 2600hz. Now this is with the RS digital meter and 1/3 octave test CD. I have found the RS digital meter to be very unreliable. For instance I used the Infinity RAMBOS (better than 1/3 octave)
measurment and found the RS off by up to 5db on the bottom.
What i havent done is un-biwire and test again.

Thanks,

Steve
Sean,

Sorry for the mutated response on my last post.. I was running out the door to go get my son.

The most important thing i didnt mention is.. i have
never measured this system without bi-wire so i
dont know for sure.

Can i just unhook one of the sets of wires at the speakers
and re-install the jumpers to test? Or do i have to take
the 2nd set off at the amp also?

Thanks,

Steve
sean, well said! i didn't think you were challenging audioengr it's not your style. i agree that we are all seeking the holy grail of musical truth and we all have our version of what that truth is. i was not challenging audioengr either he has the creds. i was just pointing out that as far as nautilus speakers go, bi-wire is the real deal.
Voodoo: I would pull the second set of speaker cables off of the speakers and take measurements with a single cable and jumpers hooked up. You can then hook things back up and take another set of readings with the complete bi-wire arrangement. I sincerely doubt that you'll see any major differences.

Other than that, it sounds like you might be running into some form of cancellation from room nodes. The spacing between 800 Hz and 2600 Hz almost equals a primary and a third harmonic, so that could be coming into play. Then again, you might have a node at 800 Hz and the 2600 Hz drop could be crossover related. Too many variables without knowing any of the specifics.

As to the RS meter, none of them are real accurate in stock form. I know nothing about the digital meter, as i've never used it or read about it, but you can probably find out how to correct a lot of the deficiencies of this unit at Eric Wallin's DIY Audio Website. Sean
>
Sean,

Thanks... That makes alot of sense... But before i pull the
bi-wire im going to set the test CD at 800 and move around
the room to see if it varies at all. It didnt even cross my
mind till you said room mode. Then if that doesnt make a
difference then i will pull the second set of wires and re-test.

I talked to Rives about the difference between RS Analog
and Digital SPL's.. he is more familiar with the Analog
but he felt the Digital is supposed to be closer to flat and doesnt require the adjusted tracks.. But if i had to
do over i would get the Analog and use the adjusted tracks
atleast they know how far off the Analog is.

Oh well live and learn... Thanks again.