power cord too short? what now?

I am with Listener57 - get a nice strip with a solid cord on it - BPT makes some very high quality gear that will probably improve your rig anyway - very tough to beat the value of the Pure Power Center for $149 which includes a 6' cord - not his best but decent, best is available =) For an extra $20 Chris will add some magic and isolate the duplexes enabling you to isolate the digital sources from the power amps etc.

Newbee,

I completely agree. Why can't people understand that that is basically what's behind their sheetrock walls? Within the same room, if he had chosen the furthest outlet location along the outlet wiring series, he'd just be adding more Romex wiring length. Its basically just a longer non-audiophile extension cord, thus the on-going beneficial "Audiophile" powercord debate. Nice fancy $$$ cord plugged into the wall outlet, then crappy ol' Romex hidden just mere inches away. Just because it's out of sight, doesn't make it magical?

Some may argue that another plug contact is made, but aren't factoring in the "series" outlet connections behind the walls and out to the breaker box (more copper and brass oxidation at each and every wire termination for those debating "gold-plated fuse" benefits).

40 years of electronics, but what do I know?

Metro04, FWIW I'm severely challenged when it comes to figuring out how long a PC should be. If one assumes that adding a particular PC improves the sound, say a six ft length, would a nine foot length sound better, or worse. Why? How about a 12 ft length. Would that be better or worse? Why? Assuming the PC is the same guage as the romex in the walls and the current is not limited by the PC wouldn't it be acting as some sort of filter for RFI etc and benefit by being as long as possible. I wonder how one determines the optimum length in the first place. Oh well, lots of questions - I'm sure there are a lot of answers. I'm just a Newbee. :-)

Newbee,

A power cord can be any length providing the conductors and plugs are rated for the current requirements. All "unshielded" wiring is susceptible to RFI and EMI influences. Shielded PC's ONLY minimize EMI (AC hum) into close proximity high signal gain interconnect cables, which most decent IC's should eliminate themselves (ie; 100% shielded vs braided only). Keep in mind that all "exposed" Romex house wiring, from each wall outlet, is "unshielded" back to the breaker box. Now, if your house wiring is ran through grounded metal cunduit, then that's different, right? So, what sonic attributes can a short shielded "grounded" PC cable offer to footage of non-shielded cable runs? That's where all the debatable controversy begins.

I'm from the camp that's doesn't believe "Audiophile" PC's can offer any improvements over "stock" cords, EXCEPT for fully shielded scenerios as mentioned above. Exotic conductors, dielectrics, and layout construction offer nothing over the remaining non-audiophile Romex wiring, standard outlet composition, breakers, etc. If you won't believe me, than obtain the proper test equipment and have it verified. Look at each and every "Audiophile" concern at the outlet, then the output of the boutique cord(s). As long as the equipment is getting it's proper "clean" voltage supply, that's it!

Look, get a range of cables on loan (speaker, PC, IC's, etc). "Stock" and otherwise. Since you should know your system's sound at this point, have a friend perform blind testing on you. Let them deliberately fool you by periods of never exchanging "stock" cabling. If you can't pick the high dollar cable(s) every time, there's your answer. This goes for even the most hideously expensive systems. Ignore $$$ ego, and prove it to yourselves...

Metro04, in case you haven't figured it out I happen to agree with you. I've tried out different cables to contrast to the heavy guage Belden which I typically use and on those few occasions when I thought I heard a difference I did not hear a corresponding change when I removed the cable under test and went back to the old Belden. But then again, my equipment is not revealing enuf, my hearing is poor, and my attention span is nil. What would you expect. :-)