Heavy Power Cords

Mmarvin19, usually I support the cable not the connector.

Try wrapping the IEC in Teflon thread seal tape (aka, plumber's tape). Use enough to get a snug fit and it will keep the cord from sagging. I find it takes about 1.5 - 2 feet. It's easy to clean up if you want to remove it as there is no residue.

03-05-09: Fpeel
Try wrapping the IEC in Teflon thread seal tape.

That's a great idea. It allows one to control the thickness of the wrap.

I tried the heat shrink tubing method, and it'd didn't work ideally for me. The Blu-Tack is a compromise.

I'm going to try the teflon tape.

Albert P

I used zip ties too. String is just cheaper and allows a bit more creative applications, eg., slings, supports, or just simple tie offs, rather than looping/stringing the nylon ties together... and it's less abrasive on the cord and rack, if things need to be slid about.

In fact I got pointed to this idea from past rigging exp. in the service. Another sure fire way is to tie off the cord just behind the connectors shrink wrap, and then run the line in a loop towards the face of the component and secure the 'loop to one of the front footers' or both in a triangle sort of affair, underneath the component so as to hide the string mo betta. Violin! ...and all just for pennies!

Teflon tape would I imagine be way better than electrical tape in terms of not leaving any goo, better heat resistance, and better "adjustability" since its so thin. The down side would be many more wraps and more patience necessary because its so thin. No free lunch.