2. cables
  3. 1236215339

Heavy Power Cords

Hello All:
Perhaps someone out there might have an answer for me. All my gear sport after market Power Cords. The issue is their weight. They tend to pull themselves out of the back of my amp and pre-amp. Does anyone know of some sort of a cable clip or stabalizer that addresses this issue.
Thanks In Advance/ DR Cervantes
cervan2281
jea48
2,944 posts
 
Teflon tape would I imagine be way better than electrical tape in terms of not leaving any goo, better heat resistance, and better "adjustability" since its so thin. The down side would be many more wraps and more patience necessary because its so thin. No free lunch.
03-06-09: Swampwalker
Swampwalker,
An alternative might be 3M 70 self fusing silicone tape. It only sticks to itself and there is not any residue, none.....
cervan2281 OP
6 posts
 
Hello All:
I would like to thank the many members that responded to my little problem. As is the norm with Gonners, helpfull and willing to take the time to help less knowledgable. All the suggestions are very clever and much appreciated.
Best/ DR Cervantes
rx8man's avatar
rx8man
1,355 posts
 
A manufacturer needs to come up with a "locking-type" or "snap-in" IEC, similar to a balanced XLR connection.
arthursmuck
447 posts
 
These work very well when stacked interlocked between your shelf or floor and your power cord...they're rubber so they don't mark anything up either...

http://www.audiogon.com/cgi-bin/cls.pl?accstwek&1239231445&/Blueharmony-Cablock-cable-isol
More to discover