Surround Speaker wire Recs - WAF need


I have gone home theater route in my old (60 year) house. We are having remodeling done and my installer tells me the only viable place is along the baseboards. I need a good and fast recommendation for this. The wire needs to be unobtrusive. Have three runs of about 45 feet Thanks. Richard
rbischoff
Many thanks for the recommendations. I don't have an attic or basement and no space to run above the ceiling. Therefore the idea on the baseboard is perfect. Ordered the stuff from Audio Adviser should be here today. Thanks for the fast responses. Richard
Dude got his wires run, satisfied his wife, and nobody insulted Carl, a pretty good day. Now if someone would get the point of Trelja's post about auctions, we hit for the cycle.
I had the same problem and pulled off the baseboards and cut about 1 inch of drywall off the bottom of the wall. Then run your wire and re-install the baseboard. It's not too difficult. Just be careful when pulling off the baseboard. It can break quite easily. If you do break it or screw it up, you can buy new stuff and paint it for a small price.
Marcy- if you use a putty knife about 4" wide at the tip and moderately stiff close to the nails, the trim pulls off easily, although the occasional break will happen. Ifyou do remove drywall from the bottom,even tho a small gap is left by the taper to avoid wicking moisture into the wall, fill the space with an expanding spray insulation. Avoid "Great Stuff", it expands too much, really bad around windows and doors. DAP makes a similar product which expands much less. The room will be warmer and the critters will have to find another way in. Routing the back is still best. Say, I wonder if a shelf made of DAP would be a good damper for the Plinius? Let's ask REDKIWI!