How about using a Denon AVR5800 with Martin Logans

I still maintain you are not hearing what the Logans are truly capable of. Because they don't shut down does not mean it is a good match. And I'm not referring to the origianl CLS. They dropped to .75 ohms. I have had Sequel, Sequel II, Quest, Request, ClS, CLS II, CLS Z etc. I have tried many amps. I don't think his question was regarding our debate of what the manual says. If you get them to work without shutting down that is great. I think most of the responses to the thread were that it would sound better not using a reciever and I will still maintain that position.
You your self stated it wasn't very dynamic but it worked. Hardly sounds like a ringing endorsement. In addition the NEW Scenario from Logan states impedance of 2 at 20Khz. Sounds pretty much like the range I gave in my previous thread. Glad it works for you but I don't believe many people including Martin Logan or Denon for that matter would say it is a great match. If Dansloane is only interested in it working and not shutting down then you are right it appears.

Jc, I agree it's not the best route to go. I only used it temporarily until I went to my present system which is of course seperate components. I'm using a Levinson 335 for the front 2 channels and a B&K 7250 for the center and rears, and of course they blow the Denon away! I read the other posts. I was only referring to him being able to run the speakers. If it's affordable he needs to go to seperates. I'm not trying to debate you, I was just giving my opinion on that portion of the thread.

Agree:)

I had Aeris I with a Marantz receiver. Pretty good, but I could get the Marantz to clip on extremely complex surround passages. Only once did it shut down. I than set up to Pre-out to Bryston 9bTHX. What an improvement. Now I have McIntosh MX 132 with Bryston. I really notice the difference on 2 Channel music now.

You must try InnerSound ESL Amplifier. It's outstanding!
IMO no receiver will be able to handle the low impedance of the Aerius i and I may add that not all amplifiers will do so either.
I had B&K Reference 7250 5 ch amplifier and was very satisfied with its performance until I auditioned the InnerSound. The difference was incredible!!! I now use InnerSound ESL Amplifier to drive the Aerius and InnerSound Home Theater Amplifier to drive the cinema and scripts. Check out InnerSound's white paper in their web site.