If you run the output of one amp into the output of another amp your going to smoke the amp even if it is off. Had a friend that had the same idea as you using a Rotel 6 channel amp and an aragon 8008bb. As soon as he turn on the aragon amp (the rotel was off) the rotel went up in smoke. Cost over $300.00 to repair the rotel. Best thing to do is to have two sets of speaker cables and just reach behind the speakers and swap cables.
An odd idea
Got a question for all of you . . . .
I've been battling with the problem of optimizing 2-channel performance without compromising the coherence of my HT setup. I only have one room which is usuable for A/V gear, and it's loaded to the gills with speakers for HT.
I'd like to upgrade my amplification for 2-channel, but don't want to have to buy SEVEN channels of "good stuff," since that's a healthy chunk of cash and I'm happy with the HT performance of my Rotel gear.
So here's the question -- anybody ever tried hooking up one set of speakers to two different amplifiers? I'm thinking of a modified shotgun biwire cable, run backwards -- single end to the speaker, split ends to two different amps. Obviously you'd have to make sure you NEVER had both of the amps turned on at the same time . . . .
It seems to me that this would be preferable to using a switcher box, because that would put an additional "thing" in the signal path, where the split speaker cables would not.
Of course, my understanding of electronics would fit into a Vibrapod, so there might very well be a screamingly obvious reason why this would be a disaster in the making . . . .
Would this work? If it did, it would allow the use of completely different amps for 2-channel and HT without having to worry about the interaction of one with another, same for preamps.
I'd really appreciate any feedback anyone had here . . . .
Thanks!
Pat
I've been battling with the problem of optimizing 2-channel performance without compromising the coherence of my HT setup. I only have one room which is usuable for A/V gear, and it's loaded to the gills with speakers for HT.
I'd like to upgrade my amplification for 2-channel, but don't want to have to buy SEVEN channels of "good stuff," since that's a healthy chunk of cash and I'm happy with the HT performance of my Rotel gear.
So here's the question -- anybody ever tried hooking up one set of speakers to two different amplifiers? I'm thinking of a modified shotgun biwire cable, run backwards -- single end to the speaker, split ends to two different amps. Obviously you'd have to make sure you NEVER had both of the amps turned on at the same time . . . .
It seems to me that this would be preferable to using a switcher box, because that would put an additional "thing" in the signal path, where the split speaker cables would not.
Of course, my understanding of electronics would fit into a Vibrapod, so there might very well be a screamingly obvious reason why this would be a disaster in the making . . . .
Would this work? If it did, it would allow the use of completely different amps for 2-channel and HT without having to worry about the interaction of one with another, same for preamps.
I'd really appreciate any feedback anyone had here . . . .
Thanks!
Pat
- ...
- 21 posts total
- 21 posts total