$ 1,000 A/V receiever recomendations...


I am needing some input on recomendations for a A/V receiver new or used for $1,000 or less. I have read many many posts and have collected some ideas. Please offer some suggestions for units that offer the "latest" technology. My system consists of a 42" Panasonic Plasma, with the Canton 5.1 audio system. Your thoughts/opinions are greatly appreciated.
mikebu
"Why tie yourself in to a receiver? It just doesn't make sense."
Not unless the receiver has an excellent processor built in, and then some. I cannot recommend the Yamaha RX-V1400/2400 more highly. Yamaha's Cinema DSPs are among the best, just add a separate amp to drive at least the main 5 channels. The receiver's amp section is fully capable of driving the last 2 channels of rear surround.

The DSP section uses 32bit processors and the 24bit DACs, while the vol control for all channels are matched to within 0.5db. Its a full fledged machine.
Denon 3803. The upconvertion is awesome! You can take any signal and the Denon outputs in RGB, one cable. It also has a great sound and the DACs are better than the Yam's as Yamaha produce in house where Denon goes out and buys the best and uses economies of scale to get the costs down. I feel safer with a Japanese made piece that that made in Malaysia. I have heard from a lot of audiophiles that there is no such reciever that is good at $1,000. I got the Denon...I like it and down the road I will add a power amp and use the Denon as a preamp until I can afford a really nice preamp. The 3803 also has more inputs that you know what to do with so you are not really limited to options.
Just add a seperate amp? Well I guess that is what I have been trying to say. And why on earth would you want to put a Yamaha in the chain? Look, I am just trying to save the guy some money in the long run. Most people end up going through several upgrades during their trials at HT. Sure know I did. Now if someone is looking to just have a nice little HT setup, then sure, go ahead. Run on down to Circuit City and get yourself a nice little Yamaha or HK (spit) or whatever brand name receiver you want. But if you want a true brute of a system. And at a reasonable cost, then buy used and do yourself a favour. Go seperates! I don't care what kind of DSP modes (?) any receiver has. Why would you want some jazzed up DSP modes anyways? You only want, DTS, DD, and stereo.