"Commercial" plasma screens the real deal for HT?


Following my other thread where I was asking for advices on $1500 screens for my small 10*11 audio-video room to be used solely for DVDs (no TV cable input), many have amswered that the best deal remain traditional CRT TVs, wide-screen (Sony Wega or XBR).
I stumbled onto a forum that advocates the purchase of commercial plasma screens (about $1500 for 42": Matrix, Hyundai or other NEC) with none of the consummer gadgets, no speaker, just component input. That would do the job for me as I have no HDMI output on my McCormack UDP-1.
What is the catch, if any? resolution (800*400 and change) too low? reliability? this seems to be a good deal to me and will not create a big mass between my audio-first speakers.

Any opinions?
Thanks
beheme
There is a thread about burn in at the top of the plasma forum at avsforum.com. A few things;

1. I have had my plasma for over 2 years and I dont see any burn in on my plasma.

2. A set is most vulnerable to burn in during the first hundred hours of use or so ( NOT an exact figure)

3. Leaving up black bars for extended periods of time CAN cause asymetric phosphor wear. I am using that term not because I am taking the SAT soon ( that was 20 years ago), but to stress that uneven phospor wear is the true danger. With black bars, that uneveness is defined as the stuff inside the black bars wears differently than the non-firing pixel black bar areas of the screen. The pixel phosphors have a time to half brightness, or a half life for all of you chemistry guys. With normal viewing, this occurs evenly over time. Constant black bars disrupts this so uneven phosphorescence occurs. Watching movies with bars, which I do frequently, will not cause this. Leaving this up for days on end might. Also, adjustments on the DVD player may change the area of these bars. Or by using the just or zoom mode they can be eliminated entirely. I leave them for movies because thats the way the movie was cut.

If you get this type of problem, use the reverso screen which turns black to white and white to black--kinda like turning jeans inside out before washing them. That can even things up.

After image burn in- a different thing entirely is what you see at the airports where old schedules can be seen on the screen even though the video data is not being actively transmitted as such. If you see this-- DONT FREAK! It is often temporary in the home setting and goes away.

The above poster is talking about the Panasonic wobbler, an anti-burn in feature like he says.

Again- check the master burn in thread at avsforum.com
I have a commercial Panasonic 42" EDTV, which is perfect for DVDs as the resolution of the monitor matches the source exactly. At a viewing distance of greater than 8 feet, there is no difference between an EDTV and an HDTV in my opinion. The only drawback to the commercial vs. consumer versions is that you'll have to buy a mount separately, as well as speakers (if you're not using a HT setup). Also they tend to use BNC connectors instead of RCA jacks. Cnet has some very good discussions on commercial vs. consumer plasmas, including Panasonic's new 50" HDTV. You can also look at http://www.plasmatvbuyingguide.com/ which has some good info on the differences.
When I got my commercial plasma, I asked for some BNC-to-RCA adapters. Vendor threw a bunch in at no cost. Problem solved.
Mine did too. The better solution is to get BNC native connects on one end and RCA on the other. The free apaptors were 50 OHM instead of the optimal 75 ohm. I have 6 in a drawer somewhere.
You know,I should look at what I actually did receive! I think the ones I got were the "better solution" ones you are using. Also, my NEC plasma has both BNC and RCA inputs.

J.