Replacing Jumpers = Bi-wiring??

A question was asked previously why aren't there more high-end speakers designs out there that are single-wired as opposed to bi-wirable. I think that most manufacturers offer two sets of posts on their speakers with the intention of bi-amping and not bi-wiring. Bi-wiring is usually a bad idea as it introduces undesirable effects like electomagnetic and RF interferences due to the two sets of wiring running in proximity, plus the benefits are questionable on a three-way design and non-existant in a two way design. 99% of the time you will be much better off investing the extra money in a better set of wires than bi-wiring. Happy listening.

It really depends. I recently upgraded speakers, the old pair sounded much better biwired. Upon setting up my new speakers with the same cables they sounded terrible. I was obviously dissapointed when my old speakers sounded a lot better in back to back comparisons. Then I set them up using a single wire and they now sound an order of magnitude better than my old speakers. I also upgraded the cable to Harmonic Tech from Kimber 8tc and the improvement is dramatic. The true test is through back to back comparison.

I have a pair of Sonus Faber Extremas. Not only did they sound better biwired but the biwire was one level lower then the single run with quality jumper.

The biwire was Mit MH 750 and the single run was Mit NH 750 Plus' yet the biwire sounded better.