How can power cords make a difference?


I am trying to understand why power cords can make a difference.

It makes sense to me that interconnects and speaker cables make a difference. They are dealing with a complex signal that contains numerous frequencies at various phases and amplitudes. Any change in these parameters should affect the sound.

A power cord is ideally dealing with only a single frequency. If the explanation is RF rejection, then an AC regeneration device like PS Audio’s should make these cords unnecessary. I suppose it could be the capacitance of these cables offering some power factor correction since the transformer is an inductive load.

The purpose of my post is not to start a war between the “I hear what I hear so it must be so” camp and the “you’re crazy and wasting your money,” advocates. I am looking for reasons. I am hoping that someone can offer some valid scientific explanations or point me toward sources of this information. Thanks.
bruce1483
Brulee, HDM -

If folks feel that aftermarket power cords improve the sound, OK! However, the ability of the senses to be mislead is legendary and I'd bet big bucks that's what is happening for most people who honestly feel that the PC makes a difference, other than instances of too-small cords or RFI issues. In the end, though, all that really matters is your enjoyment of the sound.

The people I have an issue with are the rip-off artists (either ignorant, just plain greedy or both) putting these kilobuck wastes on the market in the first place.

JHunter
Listen Albert, The differences in power cords and ICs that you ,I and others hear, are also quite audible to non- audiophiles as well. I have done the trials on many people in my sound room. I am sure Steve and 702 would hear alot of what the rest of us hear too. The simple fact is that these people don't hear the changes, because they don't want to hear them!! No amount of dialouge is going to change their philosophy. If I put these guys in a room with, say ,Radio Shack ,MIT, Siltech and Magnan cables and changed them in that order, with the same music and amplitude level, and they told me NO DIFFERENCE, then I would have to say they were flat out lying...these are not subtle changes. You dont need golden ears to hear these differences, you just have to be honest with yourself.
If they were to say, "We hear the changes, but will not support the obscene prices and therefor condemn the entire wire and cable scene as plain robbery", then that would be a more honest post.
In the end I think the driving force here is the thrill of conflict with you guys (and gals). This will continue to be a weekly battle with no results. I must admit it does draw alot of interest, but forget about the truth ,it won't happen........Frank
Albert - Since I don't know all the laws of science, it's more than a little presumptious of me to claim that an effect must be outside all known laws. So, sticking to the few laws I do know I checked the resistance and voltage drop of 18 vs. 12 gauge line cord. I know claims are made that there are other effects of some kind that are more important. Anyway, I thought you might find these numbers interesting as they help keep things in perspective.

Assuming that your DVD draws about 10 watts, a 6 ft 12 gauge cord will drop .0016 volts while the stock 18 gauge cord will drop .006 volts. Now, it is typical for your utility voltage to vary 10 volts during different times of the day. Also, good gear is design to handle two or three times that amount without any problems. So, the voltage stability provided by the larger line cord is somewhere around 1 to 2 thousand times smaller than the normal variations of the utility's voltage.

I picked my analogy of the pump nozzle effecting the performance of the car because it is similar. Electricity is pumped to your power supply where it is transformed, rectified and stored for (by electrical time standards) later use. Much like the gas from the service station pump doesn't flow into the engine, the electricity from the line cord doesn't flow into the digital/audio circuitry.

It is this tremendous isolation between what is happening at the line cord (330 peak to peak volts) and what is happening at the circuitry level (low nearly perfectly regulated dc voltages) that make it incomprhensible that the minute contributions of exotic lines are significant.
Hey Albert, have you found it odd that "the" guy who claims no possible change can take place from a power cord should have limited scientific knowledge? I must have missed something, but I was sure "he" had the answers.
Also wondering how power is "pumped", oh well guess I'll believe you in that you speak with a basis of knowledge.
All the anti-expensive cord people overlook the one fact that makes these expensive cords sound different. First they start with the false assumption that current demand by the component is somehow constant? They argue that the original factory cord will deliver sufficient current for the component to operate as designed. That is the only thing they are right about. The sonic difference comes in the PC's ability to perform during extreme dynamic changes in the music. When the music changes, the current demand by the component changes. If you choke the power supply in any way or open it up, these changes will be audible by the average person. The music is not static. Test tones are static.