Highly Polished wire????

Dan everyone knows shiny wire performs better, its gospel for christ sake! lol Very good question though. ~Tim

When metals are "polished", it is actually a process of removing metal until the surface of metal is very shiny and very clean. It's not like waxing a car where the "polish" is rubbed in and left on the car. The polishing agent can be any of many abrasives ranging from coarse to extremely fine, ie polishing rouge which is, of course, continuously removed in the process.

The other way of "polishing" might actually be plating with a metal of high conductivity-- gold being the most common plating material because it doesn't tarnish. Plating is different than polishing, and the plating metal + the bond are very important audio considerations. Cheers. Craig

That is a great point. If you use sand paper you are going to leave minute traces of Aluminum Oxide on the wire. I would suggest cleaning it afterward with water and a mild detergent. Just be sure to dry it very well to stop corrosion.

Do any manus. ultrasonically clean their cables during production?

OK say we do polish with a rouge, wouldn't by the act of polishing embed even more particles of the rouge into the metal. High purity copper and Silver are not the hardest metals on earth. Seems that the only way to polish would be to chemically treat them. Once you remove the Copper Oxide or Silver Oxide it immediately starts to form again. I am not doubting there is stuff on the surface of the wire that should be removed from the manufacturing process,like grease and stuff, but just wondering if the process of "polishing" by physical contact adds more than it removes. Would be interesting to hear how companies like Nordost "polishes" their wire. Anybody have any clue about this process?