2. digital
  3. 1090068720

JoLida 100 potential problem


Hi there,

Yesterday I recieved my Rca tubes and I immdiately installed them. Easy enough to do enough though it's pretty cramped inside maybe it's due to my level-2 mod. On to my question when I installed the new tubes and put back the metal sheaths I tried to tighten the screws but was unable to do so. I left them unscrewed in this state can a problem what so ever occur. I'm mostly concerned when moving the player that the screws will pop out.

Thanks

freakygreek
freakygreek OP
95 posts
 
Thanks again for the info. What about removing the whole base can it be done. If I can help it I'd rather not have to loosen the circuit board. This is more trouble than I bargained for lol.

Cheers
ketchup
459 posts
 
You can do it :)

Disconnect the connectors on the circuit board, remove the screws, and lift it up enough to gain access to the nuts on the bottom of the board. A small wrench set will help hold the nuts when you tighten the screws.
freakygreek OP
95 posts
 
Ketchup,

You the man your advice worked like a charm I was able to tighten 3 out 4 screws. The last one came undone completely red washer and all. I tried but it is nearly impossible to do the last one by myself. Turned it on and it plays beautifully.

Thanks again for the encouragement if it wasn't 1:00am I'd celebrate.

Cheers
usblues
1,216 posts
 
Occasionally it helps to locktite[blue] or silicone the nuts so they dont move around as you fiddle.....good luck,Bob
More to discover