How to couple my monitors to stands???


Happy New Year, everybody!

I just acquired a pair of Aerial Acoustics Model 5 monitors and will be receiving a pair of Osiris 24" stands by UPS today. I need to know what I can do to keep my speakers FIRMLY planted on the stands.

Here's the problem...For those of you unfamiliar with the Aerial 5's, they have 3 brass "cones" (for lack of a better word) that screw into the bottom of the speakers - two in the back, one in the front. The front "cone" is height adjustable and tilts the speaker back to align the tweeter and woofer. Of course, if I just set the speakers on the stands, they'll be very unstable and could easily come sliding off the stands. I've got little kids in the house, so they've got to be solidly planted.

How critical is it that the speakers be sloped? I was wondering if there might be some kind of a "cup" (again, for lack of a better term) that I could couple to the stands (with blu-tak) that would keep the cones from sliding off the stands?? I got the idea from the cups that I had to buy for a chair with casters that I was using on hardwood floors.

Any help that you can provide will be GREATLY appreciated!

BTW - I know that Aerial offers a Sound Anchor stand for these speakers, but at $500 I couldn't pull the trigger. I got the Osiris for $299 shipped.
danheather
If you are needing the most secure method then unscrew the cones , drill three holes in the stand top plate and secure the speaker with the appropriate threaded screw (into the bottom of the speaker). You will be able to use the adjustable cones on the stands for your tilt adjustment.
Bobby@merlin
sorbothane round isolation pads work great. dampen vibration and have a tacky surface that wont stick to the speakers. selling some on audiogon now.

alan
You could pull the trigger for 300 but not 500 for a pair of far-better-made and perfectly matched stands? And then try to save $ (yet increase hassle-factor) and expect a decent setup with non-matching stands? come on. Shop around. Ditch the Osiris. I am sure you can find Aerial stands for less than retail. I have a pair of 5s, the stands are worth the extra money, and mate perfectly with the speakers, securing them to the stand with 2 large allen-headed bolts. These are the best 2-way monitors I have ever heard and have compared them against many others that I have brought home. They deserve the best stands, and the correct ones. Do yourself a favor and do what you should have done to start with - get the Aerial stands.

-Ed
You don't! Get floorstanders or gt rid of kids! I guess, you should rather go with the first choice.
You also can remove the screw in feet/spikes/whatever they are and drill the plate on the speaker stand top to match the hole pattern already in you speaker. Purchase the correct size machine srew/bolt (stud would be better if you can find) to match the threaded hole in your speaker where the feet/spike/whatever they are fit be for. Be sure the new machined screw/bolt (or stud if you can find) is long enough to reach up from the bottom of the plate and allow the hight of the angle you want or to level. By over sizing the holes in the speaker stand plate slightly and using a nut above and below the speaker stand plate you can angle or level and then lock the speaker in place by thghting the nuts on the speaker plate. As you tighten the nut on the top and bottom against the plate top and bottom you will lock the machined screw/bolt in place. You will have to hold the machine screw/bolt from turning and just tighten the nuts. You should be able to set the angle by first screwing the new screw/bolt/stud in to the holes in the speaker base then allowing the nut on top of the plate to support the speaker. Then turn the nut up or down until the speaker is where you want it. Keep the srcew/bolt/stud from turning whille you srcew the nut up from the bottom and tighten the plate between the two nut by thihtening the bottom nut tight.