Peculiar problem? Show me the light...


OK, I'm going to try and explain this as best as I can. I don't usually listen at mega volumes so this has not been noticed before. My Revel M20s can handle just about anything I put through them, and my subwoofer picks up the base inadequacies. There are some pieces of music that have tremendous base punch, and at very loud volumes I hear my Revels cracking up. Not my sub, but the M20s. Both speakers. If I turn down the volume gain from the neutral setting, on my subwoofer, the crackling goes away in the M20s. It's wierd. If I play the same piece of music with the sub off, I can play at prodigious volumes with no crackling at all. How can my self-powered sub, effect what's coming out of my speakers. I have it hooked up via the preout from my integrated. The sound, otherwise, is wonderful, but at the loudest levels with some powerful transient response type stuff, it'll crackle. I hope I'm explaining this properly. This is a very livable situation, for I just, in a blue moon, crank it up to satiate a sonic desire, sometimes. And it doesn't happen with most music. Anybody have any ideas? You might need more information, so hit me. Thanks in advance my audiophool friends. warren
Here's my system:
YBA Passion Integre
Micromega CDP
Sufire Architectural sub
Revel M20s
Audio Magic Stealth
Cardas GR Ics.
Sistrum Rack system
Sistrum Mini Monitor speaker stands
Sistrum Subwoofer stand
128x128warrenh
Warren,

I don’t think the Revel produced the cracking noise. I believe your sub might have triggered some sort of vibration or resonance in the surrounding of the Revel, perhaps the join between the speaker and its stand, or the furniture nearby. The vibration was most likely airborne at very low frequency. That is why the cracking noise went away when you turned the sub down or ran the Revel by itself.

I had a similar problem a few months ago. After I upgraded to a pair of Vandersteen model 5, every time I played the Titanic CD track 1, the deep bass would cause my left speaker to buzz. At first, I thought the speaker was defected but when I walked close to it, the buzz disappeared, I then walked back to the listening chair and the buzz came back. It only happened on one or two CDs at certain volume level. I later put a pair of 16” Tube Trap at the front corners to control bass boom and the buzz went away forever. I still don’t know what was buzzing.

I hope this help.
Now, I was told, from an astute audiophool, that this may be due to, believe it or not, subwoofer clipping. The signal can back up through the preout lines and do a number on the main speakers. Henceforth: crackling. Possible? Maybe that Sunfire sub just can't handle those killer, very-low- extension transients? Just thinking out loud. Sssgot to be something coming from the Ics via the preout. Maybe I've gotton a little volume, nuts? Make sense?
I have not test the solution yet, but it makes so much sense that I'm embarrassed that I did not think of it. It took a tech guy over at YBA to explain what he thought it probably is. He said very simply that the Integre is clipping due to the sub and all my other stuff being on the same outlet. When cranking the music up the sub is drawing huge current and the Passion doesn't have enough to drive the M20s without clipping. When I shut off the sub-no problem, because the Passion has all the current it needs. The Integre is a very high current drawing amp, and the M20s very inefficient. That coupled with a thirsty subwoofer on one outlet: WAHLA! I'm going to go the sane root and keep my music at normal volumes. Makes sense now. I'll get a long extension cord and run the sub through another separate current-outlet, just to make sure, but that is the deal. Thanks again, warren