Subwoof Piega P10s for bass Quality, not Quantity?


Can a subwoofer be used to improve the quality of a system with too strong bass? I have Piega P10s & would like a tighter, more controlled, even reduced bass. (All other aspects of the P10s sound is, to my ears, wonderful.)Thanks to members for any suggestions.
rgs92
R U saying that the P10s have too strong bass? If so, I'm guessing that what you're hearing is a peak in the speakers' in room response around 80-100Hz. Try pulling them further away from back wall -- or even, try listing them a tad higher off the floor.

Adding a subwoof should give you low bass extension not a bad thing. But first, bring the system sound to where you want it, soundwise, THEN, add the subwoof(s). IMO, etc.
I've used my Rel Stadium 3 with the P10s (just for fun, I bought the Rel for use with other speakers) but the unadulterated Piega bass is far superior. Sounds like a room/placement problem to me. I assume you've already attenuated the bass using the switch at the rear of the speaker. That pretty much did it for me in my room. But I use my P10s nearfield, so the wall doesn't reinforce the bass. Try Aurios, Stillpoints, Sistrum platform or other resonance control devices under the speakers to tighten bass and focus image (good advice for any speaker, IMO).
If these things don't work, and if you're committed to the Piega's, look into your electronics to solve the problem. Amps with high damping factor (my Belles 350 monos are a good example) can really put an iron fist on the bass.
A high damping factor contributes to more consistent sound from speaker to speaker with the same amp. It doesn't necessarily provide more "authority" or "grip" in terms of bass control. That has to do with current capacity and circuit stability. This is NOT to single out Dlshifi's response, as this type of belief can be found EVERYWHERE in audio, even from EE's, engineers and manufacturers. Should we start another thread about this subject? It would go hand in hand with the "sloppy" bass response found in the mega-dollar Stereophile speaker thread.

Rgs: work with room placement. If that can't get you where you want to go, try installing various quantities of polyester fiberfil in your speakers. This can be purchased for less than $2 per 20 ounce bag at Wal-Mart. By varying the quantity, density and placement of the polyester, you can fine tune the bass response of the system to suit your needs. Sean
>