VTL MB-450 "Generations"


I read the following in a 'goner's virtual system (from a 2004 Sterophile review).

"Since Chip Stern's update on VTL's second-generation MB-450 Signature back in October 2002, the amplifier has undergone further changes and improvements. It now features a completely redesigned input stage that incorporates advances made during the development of VTL's mighty Siegfried monoblocks."

This implies to me that there are at least 3 "generations" of this amp.
1 - When first introduced
2 - Available at the time of Oct. 2002 review
3 - Sometime before April 2004 when above line was printed
(they have a new version on the way but I won't count that)

Does anyone know how you could tell what "Generation" you had, serial number? other markings? Can you get a 1G or 2G upgraded to a 3G? If anyone is "in" on the nuances of the MB-450's life I would be interested in learning more.

Thanks for your input.
128x128bmcleod
I believe the second generation VTL is primarily the same amp with a resistor upgrade that reduces risk of catastrophic failure to the big electrolytic caps and performance improvement provided by replacing the MIT caps with Infinicaps.

I have the factory pictorial instructions and spare upgrade kit for the VTL 750 sitting on my desk. It contains approximately 24 resistors and 24 diodes. I don't know the count on the caps (they’re installed in the amps).

I'm guessing the "new" upgrade is the super balance input and frankly I am not all that excited about it. The VTL is basically a single ended design and the addition of a super balanced through either transformers or transistor circuitry is rumored to be more "electronic" and "mechanical" sounding when compared to the simpler (original) circuit.

The newest version, assuming it's following the 750's (correct me if I'm wrong) is likely the addition of a mess of electronics that auto bias the 6550 output tubes. From discussions with several audio buddies, the word on the street is the new auto bias circuitry harms the sound in addition to listing for $45K (on the 750 model) compared to the original $20K retail price.

If you want an accurate run down as to where a specific serial number ranks in the upgrade path, there is no better person to ask than Bea at VTL. Of course along with the information provided, you will be told that the more expensive, latest versions are the best.

Good luck with your search.
I believe the first significant upgrade was the "Signature" version output transformers (although I'm not completely sure this basic amp actually went by the "450" designation and used 6550C's before those transformers were incorporated). In any case, taking that version (introduced around '96 I think, supposedly concurrent with a leap in build quality) as the baseline, the next significant changes, in addition to the resistor package mentioned above, also upgraded the B+ fusing to 600v ceramic types. Coupling cap upgrades may have been optional during this time. Likewise the external 'soft-start' modules, which I think became standard somewhere along the way (with a price increase), maybe at the same time the 'super-balanced' input circuit was introduced.

This last significant change might also incorporate upgraded caps as standard, but I'm not sure about that either. This version cannot be upgraded to from the previous versions, the circuit board is too different. I can't comment on Albert's info that this version may not sound as good as the previous Signature versions, but Bea has told me that the new input is not as big a sonic upgrade in her view as are the better coupling caps.

Personally, if I were in the market for these amps I would try to go with '98 production or newer (this is what my 185's are, and I think they're more nicely turned-out than the '96 example I've seen -- don't know about '97), and either stick with ones that came originally with the higher-rated fusing or were upgraded at the factory, or else be prepared to do the same if they predate this improvement (as I did). If you can find a pair with either the MultiCap or InfiniCap upgrade that's great, but if not you'll probably want to figure on upgrading these yourself (I'm planning on doing this, but not through the factory). The soft-start modules are probably very optional unless you have a chronic problem with tripping your line's circuit-breaker upon turn-on of one monoblock.
Zaikes, good additional information.

I'm pretty sure the cap upgrade path removes the MIT's and replaces them with Infinicap. Between the guys in my group and those I trade data with we have upgraded eight VTL amps and this is one of the more important things you can do sonically.

I forgot about the Signature transformer update. I have not shopped for a pair of VTL's old enough to exclude that possibility. It’s certainly an important upgrade.

I will warn those that ignore the resistor upgrade, I don't know if it applies to the 450, but the 750 can tear itself up if the old resistor package fails.

One member of my group had this happen and one or more large electrolytic capacitors failed, sounding very much like a .22 caliber hand gun as it forced the rubber safety plugs out and died. Fortunately the VTL is so well designed there was no sparks, or danger, the fuses cut all the power and no one was ever in danger.

However, the cost to make this additional repair was in excess of $1000.00. I would do enough homework to insure that safety upgrade was done if only to save yourself from future repairs.
Wow! That's what's great about A'gon, not just facts and information (which is what I was looking for) but interpretation of the information and advice about what's most important.

So along the way there was: A signature output transformer, Resistor changes, InfiniCaps, B+ Fuse change, Soft start modules, Super Balanced input circuit.

I talked to a dealer today about the newest versions to be released soon and he did mention the auto-bias circuit (which I can live without) along with the new cosmetics (that I happen to like).

I will drop Bea a line to see if she can put the upgrades together with a serial number.

Thanks Albert & Zaikesman for your informative posts, it's exactly the info I was looking for.