Speakers A and B simultaneosly in different rooms


I would like to find the best way to run music simultaneously out of two sets of speakers on diffent sides of the house. What is the most effective method. Would it be to connect the amps/preamps of the the two sets (if so, how?), to use a common source with 2 outputs and run an individual line out to each amp, or to find an amp with A and B speakers, and run a long speaker wire to the next room.
Note the two sets wont be more than 20 feet apart.
Thank for the help.
dylano
Thank you for all this valuable imput!
I like the idea of running two different amps through dual outputs from the pre. Currently I have been running two rca cables (one a 20 ft. extension) out of my source ipod(lossless encoding.)One through the headphone jack (not as desirable) and one out of the dock. Does anybody have an opinion on whether this set up (or dual rca from any source with dual outputs) is better or worse than a preamp with dual outputs.
Thanks!
Dylano, I'm not sure I understand your question.

Are you asking if the output from an iPod going is going to be as good as the output of an external preamp fed by that same iPod? What is the rest of your current setup, how are you amplifying the two iPod outputs?
I was think of having 2 complete set ups of speakers/ pre/ amp. With the ipod on a cradle, I can run two independent rca cables from this source. I would feed one into each preamp. Currently this is what I am doing, but I am using 2 integrated amps. I will be upgrading to the two sets of separates. Please let me know if this is a bad idea. I apologize if this is difficult to understand- I know I probably lack the proper terminology. Thanks for the help.
Ok, I get it.

It's certainly possible do what you're talking about but I don't think going to separate amps and preamps is going to get you anywhere.

The iPod is a fantastic device for its intended use but everything about it is designed for portability and convenience first, then for sonic fidelity. Both the outputs available to you from the iPod have already gone through the iPod's digital to analog converter and, in the case of the earphone output, through the internal amplifier of the iPod, as well. Switching from integrated amps to separates downstream of that process isn't going to do anything to improve that original signal.

It's cool that you're starting with lossless files but I doubt you can hear any difference between those and mp3 files at 192 bps if you're using the iPod as your source. I'm not sure I can hear much difference between those and I'm going digital from an iMac through iTunes to an external DAC and then to a very high-resolving amp and speakers.

To make any substantial improvement in the sound I think you'll need to spend your money on a hard-drive/iTunes based system that will let you take the digital signal to some kind of external DAC and then on to your amps and speakers.

This isn't a knock on the iPod, it does what it does extremely well, but good systems are all about balance and it doesn't make any sense to me to spend money and effort downstream unless you're starting with a better signal upstream.