Hmmm, if you turned the volume all the way down and pulled the speaker connection, that in and of itself would not likely damage the amp since there's no signal to the amp. Still, not a good habit to foster. Had you shorted the connections on the disconnected wire you would likely have blown a fuse (assuming they are fuse-protected). Could you have crossed the terminations and shorted the amps? That's very easy to do with a speaker wire flopping around. Regardless, short of the tubes being bad, it seems like you should take the amp to someone who has the expertise to test out individual components within the circuit. I don't think damage will always necessarily be visually evident.
Have I damaged my amp?
Hi,
I have a Music Angel 300B amp which has been fine for sometime now. A friend visited to hear the new single driver speaker cabinets I've made, to compare these with my previous Kef's (the amp had been on for hours) I unplugged the Rt channel only and we had a listen for 30secs or so then I swapped back, the amp was still on. A few days later it started making loud rustling sounds 'under' the music (not volume dependent) on the right channel with some squeal when I tap the chassis, there is also quite a lot of noise when I power down from the Rt channel. I have tried swapping the valves with no change and have checked inside for loose connections 'bulging' capacitors etc and can see nothing wrong. So is this a probable cause for damage and what could it be? the problem is becoming noisier but only starts after the amp has warmed up an hour or more. My first thought is to replace the main capacitors under the transformer. I don't have a schematic for it but does anyone have any views on this.
Thanks,
Iain
I have a Music Angel 300B amp which has been fine for sometime now. A friend visited to hear the new single driver speaker cabinets I've made, to compare these with my previous Kef's (the amp had been on for hours) I unplugged the Rt channel only and we had a listen for 30secs or so then I swapped back, the amp was still on. A few days later it started making loud rustling sounds 'under' the music (not volume dependent) on the right channel with some squeal when I tap the chassis, there is also quite a lot of noise when I power down from the Rt channel. I have tried swapping the valves with no change and have checked inside for loose connections 'bulging' capacitors etc and can see nothing wrong. So is this a probable cause for damage and what could it be? the problem is becoming noisier but only starts after the amp has warmed up an hour or more. My first thought is to replace the main capacitors under the transformer. I don't have a schematic for it but does anyone have any views on this.
Thanks,
Iain
- ...
- 14 posts total
- 14 posts total