Blown CS7.2 Tweeter/midrange

I own the Thiel CS 6 driven by a stereo Bryston 14BSST 600 watts into 8 ohms. And 900 watts into 4 ohms. The Thiels like a lot of current before it can sound good. I have a medium size room and normally play at medium volume. Although I've never had any tweeter problem I am careful not to overdrive my speakers. The Art Pepper meets the rhythm section is quite dynamic. When played at a slightly louder than normal setting there is quite a lot of current going to the tweeter because Thiel runs their drivers with a 6 db crossover. Most manufacturers use a 12 db crossover or higher. I believe the cause of the tweeter failure is too much current going to the tweeter. The tweeter's voice coil is quite thin and cannot tolerate too much current going to it. I am interested to hear what findings if any that Thiel's find about the blown tweeter.

Tom_hankins,

What big Krells are you talking about? I used to own JC-1 that sounded fine, but not great. I also had a pair of BEL 1001 mono blocks that sounded great, but the Lamm 2.1 is the best. Well, now I am re-thinking about this and may need to change amps. I will report what Thiel is going to say.

FWIW, I tend to agree with Tom. IMHO, the Krells are hard to beat on Thiels. BTW, I run Threshold with my (older)Thiels.

I am using the FPB 650M monoblocks. But someday when my wallet is fatter, I am going to go with the 750 cxm monoblocks. :)
Whats funny is I had never been a big fan of the Krell amps until I heard them with the Thiels.

90 db SPL should be ok - but some music is extremely dynamic and you may not be seeing it on an SPL meter.

Bass heavy material (while not loud) can cause an amplifier to easily run out of juice and clip....the clipping heats up voice coils and of course the wee VC in the tweeter goes first.

If you like to play music really loud then you are probably exceeding what this speaker was designed to do. It is a particularly difficult low impedance load to drive - so you need to expect troubles if you really push your amp. An easier load would be more amenable to being driven hard. Some speaker drivers are also designed to hold up better to being abused.