What do you see as the downside of tubes?


I have decided on getting a tube amp and it will be the integrated Mastersound 300B driving a pair of Living Voice Avatars, so at least that decision has been taken.

My main question is what you see as downsides of having a tube amp. As I've decided on getting an integrated tube it's really about what the downsides are I might want to know about beforehand.

The ones I'm aware are the following.

-The tubes need to be replaced and in the case of a 300B this will be somewhat costly.

-Bias is another issue but I'm not sure how big an issue. Do you plug in your meter every so often or just when you roll tubes or replace a dead one? The meter as such isn't gonna be a big issue as I don't think it's that expensive.

-Heat won't be a big issue as we have no kids nor a nosy dog that could get burned. Hope my electricity bill isn't gonna go through the roof, but then again, I can't quite imagine that.

I'd appreciate if you could add whatever your experiences are regarding this question are as I'd like to know more before I buy it.

Thanks
krauti
My tube amp (Pacific Creek E34i - 45 Watt PP) has difficulty sourcing a lot of current needed to drive speakers with low impedance in the lower registers. I've found this to be the case with my Vandersteen 2s. However, in the case of my Monitor Audio Silver RS6s, they are high enough efficiency and don't have such an impedance dip at low frequency to cause a lack of dynamics and transient response in the low end.
I'll quote from my virtual system:

...I wanted to go back to solid state. I've had tubes for years and loved them. I mean really loved them. However, there are compromises I'm willing to make because 1) I want something I can leave on 24x7, 2) I need something that doesn't generate as much heat, 3) I don't want to continuously wonder if a NOS set of Pope 6SN7s sound better than my NOS RCAs or if my 12BZ7s are aging and need to be replaced, and 4) I want hardware that doesn't require as much real estate.
I've owned some very good and quite expensive SS gear over the years but none of it has ever sounded(to my ears) as believable or satisfying as even modestly priced tube gear.

Many years ago, after hearing so many good things about tubes, I decided to replace my SS Symphonic Line RG-4 monos($9800pr) with a pair of 60wpc QuickSilver's(maybe $1500 pr). Long story short, no contest. The QuickSilvers just plain sounded more believable; more flesh on the bones, more relaxing and just plain more enjoyable. I found myself listening more often and for longer periods without the usual boredom setting in. The only downside to the QuickSilvers was their rather wimpy bass but I really didn't mind since everything else was so good.

After three years with the QuickSilvers I moved on to CJ monos(2 years), VTL monos(7 years) and five different CAT preamps over at least 15 years. Other than a power tube in one of the CJ's causing me some minor grief and an occasional re-tube, all of my tube gear has been trouble free

Over the years I've auditioned various SS amps and preamps and as good as they've been tonally, they always come across sounding 2-dimensional and rather uninvolving(to me).

Currently I'm suffering(NOT) with an Atma-Sphere MP-1 Mk3(w/phono) and MA-1 Mk 3 monos. Let's see, that's 56 tubes not including the four in my tubed CD player. For almost two years my A-S gear has been totally trouble free and the Telefunken ECC88's in my CD player are still kicking after being used in those 5 CATs over the 15 years. Not bad!

The downside to tube gear, it can be addicting. You probably won't want to go back to SS. Yah, you may have to bias your integrated on rare occasions and depending on how hard the tubes are driven you may need to replace a few of them over time.

Unless you're completely neurotic I doubt you'll be worrying about the status of your tubes while you're enjoying the music. That has got to be one of the lamest reasons for not going with tubes I've read!

Heat may or may not be an issue depending on your room but even with my 28 power tubes running Class A, it's not for me.

As EveAnna Manley would say, "Tubes Rule".
If a tube amp (or a class A solid state amp, for that matter) is located in close proximity to a room/house thermostat, it can create havoc with maintaining a constant room or house temperature.