Herron VTSP-3A

Kclone and Sflazor,

What amplification are you using with your VTSP-3A's? I', running my VTSP-2 with Herron M-150's right now and I'll tell ya, there much be some sort of synergistic effect going on because the M-150's sound like they've been put on steroids since introducing the VTSP-2. I was using an Ultraverve with very good NOS tubes before introducing the VTSP-2 into the mix.

Bill

Bill, I bet there is no doubt there is great synergy between the VTSP-2 and the M-150s. For me, I am using the Modwright KWA 150. I thought about maybe getting the M-150s, but now I just do not see the need, since introducing the VTSP-3A I don't see the need to do anything to my system. I had planned on playing around with speaker placement, not now, everything sound so good. I am planning on doing some room treatments, but again I don't see the need(however, I'm still going to go through with room treatments.) It is kind of like the VTSP-3A took care of all the sins in my system. How about you Bill, are you thinking about moving upgrading to the VTSP-3A?

Slazor, good post. like you I have heard my fair share of preamps. I have had preamps from Thor, Unison Research, PS Audio, ASL Twin Head II, Pathos, Audio Research REF 5, Red Wine Audio Isabella, and Musical Fidelity. I'm not ready to say it is the best out there, but it is certainly better than anything else I have heard or had in my system.

Agree on all the comments about the spectacular sonics of the VTSP3a (Disclosure: I sell Herron gear, Departure Audio). What I think doesn't get recognized enough with this piece is how intelligently it's designed and how good the ergonomics are. There are really useful features in this pre, i.e. balance, mono, phase, hi/lo gain, more than enough inputs/outputs, etc. It's also a joy to use with a large, readable remote-controlled volume display in fine increments. As noted, the tubes are run very conservatively and produce almost no noise. Reliability is also first rate. This is a very easy tube preamp for any music lover to own. It can assimilate easily into most any system and deliver its special magic immediately.

Billspecfoc inquired regarding what amp I am using with my VTSP-3A. I am using a Jeff Rowland Model 10, which is a two chassis (separate control unit and power supply) 150 wpc solid state amp that I love. The synergy with the Herron is perfect. I have also used the Herron with an Reference Line amp that has 100 WPC pure Class A output. The Herron was perfect with the Reference Line also. One nice feature of the Herron is that it affords the user the ability to switch the preamp between a low gain and a high gain setting. With the Reference Line amp I use the low gain setting, but with the Rowland I prefer the high gain setting. The preamp is dead quiet on both settings. It is easy to switch between the two gain settings. One merely holds down the "phono" button for three seconds and the preamp switches from one gain setting to the other. When the preamp is switching from one gain setting to the other, it automatically mutes itself. Keith Herron thinks of everything.

Hi Guys, you have really stirred up my anticipation. My VTSP-3 is at Herron Audio now being updated to the 3A and I should get it back the week after next.Keith's audio equipment is everything that you have already stated,the best that I have ever used. I am using the Parasound Halo JC-1 mono amps in my system with the VTSP-3a.
Great gear.
carter