Ron, I have had 1.7's for 4 months and had 1.6's previously. The 1.7's are definitely a better speaker all the way around. Since you are over 400 hours you definitely know that the bass improves dramatically. I use to run my 1.6's with tweeter out and listened to my 1.7's that way up to the 200 hr mark. I then swapped positions of the left and right speakers putting the tweeters in. Everything seemed to gel with the tweeters in. All the tweaks I have done on 1.7 are reversible atleast until the warranty period is up. So far, I have Mye Stands, replaced metal jumper bar (tweeter atten) with 3" wire jumper w/bananas and replaced stock fuses with the HiFi Tuning fuses. You can take backplate off and easily bypass fuse and tweeter attenuator too without any expense.
Tweaking the Magnepan 1.7s
Looking to tap the Audiogon crowd to come up with inexpensive tweaks for my new Magnepan 1.7s. Here is what is planned so far:
Have room treatments. I am a bigger fan of sound absorption than sound dispursement. I have four 2' x 4' x 2" sound absorption panels that sit on each side of my stereo shelving unit between my speakers. Does a great job of removing the reflections off of my electronics.
Having Magnepans for 30+ years, I do like to deaden the front wall behind the speakers a little bit. From hanging an oriental rug to curtains or whatever. Will be trying out some of these ideas with my new location.
Mye stands. I am waiting for my bank account to grow a bit before I go for these. I believe Mye has the new updates for the 1.7s (although, I can't see any difference between the 1.7s and my old 1.6s).
I want to bypass the fuse and that stupid metal jumper with the least disruption of the speaker itself. Anyone remove the back panel and replace with better speaker connects? If so, what do you recommend? How about wiring tips - anything I should be know before I start the project?
Debating on using a 1 ohm resistor to tame the high end. Any suggestions for high quality 1 ohm resistors?
Anything I am missing?
Sound notes: full description of my experience with Magnepan 1.7s and the electronics I am using in other Audiogon threads, just search for ronwills.
Have room treatments. I am a bigger fan of sound absorption than sound dispursement. I have four 2' x 4' x 2" sound absorption panels that sit on each side of my stereo shelving unit between my speakers. Does a great job of removing the reflections off of my electronics.
Having Magnepans for 30+ years, I do like to deaden the front wall behind the speakers a little bit. From hanging an oriental rug to curtains or whatever. Will be trying out some of these ideas with my new location.
Mye stands. I am waiting for my bank account to grow a bit before I go for these. I believe Mye has the new updates for the 1.7s (although, I can't see any difference between the 1.7s and my old 1.6s).
I want to bypass the fuse and that stupid metal jumper with the least disruption of the speaker itself. Anyone remove the back panel and replace with better speaker connects? If so, what do you recommend? How about wiring tips - anything I should be know before I start the project?
Debating on using a 1 ohm resistor to tame the high end. Any suggestions for high quality 1 ohm resistors?
Anything I am missing?
Sound notes: full description of my experience with Magnepan 1.7s and the electronics I am using in other Audiogon threads, just search for ronwills.
- ...
- 74 posts total
- 74 posts total