2. amps-preamps
  3. 1332877392

12BZ7/12AX7 vs. 5751

I have a Cary V12 with 12BZ7 tubes in the input. I read an article last night that suggest that the 5751 is interchangeable, just with less gain, and that it sounds significantly better. Has anyone used a 5751 in place of a 12BZ7, or for that matter a 12AX7, and could you comment on any differences/improvements in sound?

Thanks!
grimace
grimace OP
624 posts
 
Sam, thank you for the backup. Clearly one of those salesmen who wonders why he never sells anything.

I went to my favorite secret old TV store with thousands of tubes lying around looking for a pair of 5751s, but he didn't have two. However, he did have an NOS pair of GE 6BQ5s which - probably because they're fresh - are a bit of an improvement over the old Mullard EL84s. So... you never know what you're going to find.
sounds_real_audio
677 posts
 

I just don't get the whole tube rolling deal.
andr
109 posts
 
"I just don't get the whole tube rolling deal."

I must respect your opinion since you are a dealer, with lots of experience I presume. I will put aside some thoughts I might have, being on the other side of the coin.

But I would like to understand your recommendation since you went directly to the speakers. Why not the source, the amp, cable changes, room or power source treatment ? Can you explain why go immediately for an expensive solution ?
phillyb's avatar
phillyb
233 posts
 
5751 sound thin, if you like a more solid state sound then go 5751's. Joe's Lore is what he heard in his system with his ears and his likes. Nothing wrong with that, but it does not make for in stone what tube is the best for your system and your ear and bias.
facten
931 posts
 
surprising comment " i just don't get the whole tune rolling deal" given sounds real audio that you sell tube gear - try it you might be amazed
More to discover