sound22card
Responses from sound22card
| Ancient Ohms I was more concerned with the 15 ohm speakers. What limitations should I look for in a small amp with them. I don't want to mismatch them or cause damage. | |
| Just wave! Thanks, Duke. This helps a lot.Would a rear-facing or top or bottom facing vent help, if it was expelling an opposite phase signal? The room them comes into play to disperse that signal, correct? Is it true that a TL is also meant to lessen the... | |
| Ohm alone, on the phones. Curses! Foiled again!Thanks. | |
| Mystery switch I guess I shouldn't mention my DAT player then. | |
| Greenhorn question: Beware! Honest thanks for the help. With more info like what was given above, ...at some point, I will not have to ask simple questions. Thanks a LOT! | |
| Greenhorn question: Beware! Again, ...newbie here, ....Is there a capacitor or inductor that could be added in my case, to bring the final impedance into a normal range? (I just want to get this playing music, so I can continue studying audio electronics. haha) | |
| Reasons Are you saying we could build a TL speaker enclosure, to accepted design, ....and then play around with the exit size to see if it enhances the sound? (along with changing the stuffing and its placement) This sounds like 'fun' to me! | |
| Reasons Thanks for the education, people. I don't underestimate its value. | |
| Reasons These were all good links. Thanks, guys. | |
| Simply speaking! The free air resonance at 60 Hz seems like it wouldn't interfere, in most cases. Good choice, me thinks. | |
| Neutral or Detailed. You can't have both Hi-Fi speakers seem always to be compensating for something. Studio monitors don't, but in comparison, might sound dull to some. I'll go with the accuracy of monitors everytime. | |
| Simply speaking! The Dayton Audio DS 175-8 6 1/2" ...and the ES 140 TiA-8 5 1/2" look good to me. Am I on the right track? | |
| DIY ?uestion Wow! Excellent info! (especially for the uninformed). Thanks, people.I was intending to use an 8" full-spectrum speaker of quality (and cost). I will stick to a known plan for the box until I get more knowledge. | |
| DIY ?uestion I am a woodworker who builds one-of-a-kind, exotic, high-end furniture. I think I'd like to see those plans...if it's not too much of a hassle to find them.And thanks for the info. It's invaluable. | |
| DIY ?uestion Thanks for the education, guys. Sheesh! ..they sure jam-packed these TL units with stuffing. |