about to jump into the power cord foray


I am about to jump into the power cord foray. Since I’ve upgraded my IC’s and speaker cables most recently, I think the next step should be to look towards replacing the stock power cords. My system is as follows:

Dynaudio 52SE bookshelves
McIntosh MC2105 power
Audio Research LS-7 pre
Adcom GCD-600 cd changer
Lite Audio DAC 60 dac
Rotel RT-1080 tuner
Audioquest Diamondback & Kimber Hero IC’s
Kimber 8TC cables

I intend on putting IEC sockets on the A/R, McIntosh, and Adcom in the next week. If I could find a high quality changer, I’d probably dump the Adcom but I haven’t seen anything that’s really in my price range. Since I don’t have a new power or pre amp in the budget for the next 2 years, I plan on adding IEC sockets to the aforementioned devices. Will I notice any sort of improvement in sound quality, by going with Signal or Element cables with my current equipment? If not, should I look at a cable in the $100-150 range like the Virtual Dynamics Power 3 or VH Audio Flavor? I’m also open to any used cables on the site in the sub $150 dollar range
iggyminn

Showing 2 responses by bar81

Guesses and conjecture are no substitute for experience, and no, "midrange" systems do not get you anywhere near the ideal ime.
Concur. The resolution of the system is critical in terms of the need for higher quality cables. For example, when I was using B&W 804S speakers, I could get away with bettercables.com cables (and they sounded good) but when I moved up to B&W 803D they sounded horrible and were replaced in short order. So, essentially, be happy if you have a lower resolution system as you can get away cheap on cables (I know my wallet wishes I would have stuck with the 804S :))