1. Home
  2. cables
  3. 1136617124

Bi amping and cabling

I have two Carver amps that I use to Bi amp my NHT 2.9's. The question I have is what is the proper way to split the signal coming from the pre amp and deliver the left and right channels to both amps. I am currently using some simple "off the shelf" Y splitters. What should I be using and should these be customs made? It doesn't make sense to use a 1 meter pair for a relatively short interconnect.
fwitt1

Showing 1 response by rjs5

rjs5
22 posts
 
I actively biamp. In my system, the crossover has a pair of interconnects from the preamp to the crossover. From the crossover, there are two pairs on interconnects to the amps. You can get active crossovers from Marchand, Bryston among others (do a search and there is plenty information about this.)

Good luck,

Reg
More to discover