Dared Tube preamp/amp??


I just now learned about Dared tube equipment. The price definately seems right, but I know nothing about them. Has anyone used these? If I get the SET tube amp to go with the preamp, what speakers are good to use? Will they run Wharfedale Diamond 8.3? I am looking for a relatively low budget system, but with good sound quality. Also considering Jolida integrated amps (to give you an idea of what I'm looking at).

Thanks
glfrancis2050a
The VP300B with upgraded tubes, capacitors, diodes, and resistors, as well as silver wiring and the volume/preamp section bypassed bested my prior Audio Note Conqueror amplifier.
I bought the SL-2000A tube preamp.
I paid $330 shipped (New)
I added some good NOS 12AT7's and a NOS rectifier tube.
This preamp replaced a well regarded (Stereophile Class B) $1500 tube preamp.No contest!
I tried a dared vp16 and am very impressed with it after replacing the chinese tubes with nos red base/ jj telsas. I belive that there is nothing beter for under 400$. Try one, dont like it sell it.I doubt youll be dissapointed. There is one on E-bay with 3 sets of very desireable tubes now, and going very cheap.
Have a Dared 845 Integrated amp. Pretty nice fit and finish. Great sound for the money. No problem thus far for 4 months now. Purchased it new. I think it's nicer sounding than most of the Jolida amp I have heard.

I did have to change out the factory tubes. Nothing fancy. Just change to Valve Art 845, EH 6SN7 and NOS GE 12AX7. Still looking around for a better pair of 12AX7. The factory input tubes were not very good sounding and one of the factory 845 arrived DOA.

Service was my primary concern, but I think a SET amp is easy enough to service if you have the circuit diagram.

For most SET amps, look for >6 ohms impedance and > 90dB efficiency. Also make sure the impedance curve does not have a lot of peak and valley. Something like a 8Ohm speaker with a 3 Ohm dip will usually sound lousy at specific frequency range.

Email me if you have any other questions.