1. Home
  2. analog
  3. 1185196965

How to remove a 'press fit' steel ball bearing?

I'm doing some work to my Russco turntable. I need to replace the ball bearing in platter shaft. This bearing is pressed into the end of the platter shaft and cannot be just 'popped' out. It has to be forced / pulled out. Being pressed into the shaft, there is no way to get a grip on it to pull it out. Someone suggested that I heat the end of the shaft which would cause it to expand so the hole in the shaft would get bigger and the ball bearing would drop out. I tried that to no avail. Someone else tried to explain a removal method but I think he never really understood how this bearing is set. So, I'm going to try to explain this so that it is more clear.

Imagine that you are holding in your hand a 6" long steel rod of about 1" diameter. You turn that rod so that you are looking directly at one of the ends (you are seeing a 1" diameter circle). In the center of this end a hole of about 3/8" has been drilled. Into this 3/8" hole a ball bearing has been pressed so that approximately 1/2 of that steel ball bearing protrudes from the end of the shaft. How do you remove it?
kwillisjr

Showing 2 responses by kwillisjr

kwillisjr OP
2 posts
 
I first tried heating the shaft to no avail. Heating the shaft seems to have hardened the oil that had seeped past the bearing over time making it much harder to remove. I finally got that one out using a tungsten carbide bit in a dremel tool. My recommendation is "Do Not Heat the Shaft". I had another Russco platter needing the same work as well as both thrust bearing holders. For those I used a rotozip tool with a thin metal cutting blade. I very carefully cut a slot in the bearing and used a large handled screw driver to twist the bearing until it popped out. It took maybe 15 minutes to do all three.
kwillisjr OP
2 posts
 
Thanks for your responses. I actually have two platters and bearing assemblies at the moment. This is not the only table I've ever seen that uses a single ball in the end of the platter shaft. It is the only one I've ever seen that actually uses a second ball in the bottom of the bearing well as a thrust bearing. One of these bearing assemblies came from a table that was bought in the early seventies, used on weekends for a couple of years, and then left sitting in the intervening years. Because of the bearings just sitting there, both platter and thrust bearings developed flat spots. The other bearing assembly could possibly be polished out (and it sounds like that may be the preferred option). So, anyway, I'll think about it and see.
More to discover