1. Home
  2. amps-preamps
  3. 1419080520

SME V problem

I have a problem with the armrest on my SME V tonearm. It should stay in place but it doesn’t. It has always been a bit loose and has become worse. When I push the arm out of the armrest clamp, the whole armrest swings inwards. This happens also with the base screws tightened. I have to push the armrest back again to maintain the right position. Does anyone know a fix for this problem?
o_holter

Showing 3 responses by o_holter

o_holter OP
541 posts
 
It turns out that the solution is simply to tighten the two base clamp bolts even more. The SME V manual (p 17) says that "excessive tightening" should be avoided, but in my case it has to be very tight indeed to stop the armrest from moving.
o_holter OP
541 posts
 
Dover - yes, it is the whole arm, and tightening the base screws helped. Syntax - thanks for the warning. I hope it isn't caused by oil spill (from the damper reservoir). Perhaps I should try to clean the arm.
o_holter OP
541 posts
 
It is fairly smug and fit, with the screws more tight - no big problem.
Some comments are invaluable, you only get them here on Audiogon. Like,
"Be careful ... The next step after "tight" is "broken" :-) " from syntax.
More to discover