Trelja, thanks so much for sharing your knowledge. I inspected the crossover for the tweeter with greater scrutiny. My memory is cruel to me indeed. In fact, there are six components on the tweeter board with a rather confounding wiring pattern.
There are three rectangular resistors. All have values printed on top. The large black and yellow Cap I previously mentioned, a much smaller black and yellow Cap(?) 1/4" in diameter and 1.5" long, and an air core inductor. The Caps and Inductor do not have values (Microfarad and miliohms, Right?) I cant seem to locate the Ohm symbol so I will write ohm in its stead.
A 10w6.2ohmJ resistor is feed Positive in (from amp) then to the large Cap then to the coil which then splits and goes to the Negative tweeter terminal and the Negative Amplifier in. This seems odd to me. But I digress, my knowledge in this area is extremely limited.
The large Cap has two other leads. One leads to another resistor (10w15ohmJ) which then goes to the Positive tweeter terminal..
The other feeds the smaller Cap then another resistor (10w4ohmJ) and the positive tweeter terminal as well.
So which resistor should I jump? ....or should I just go watch some preseason Football and shut my pie hole?
Autospec, thanks so much letting me use your thread =)