Static on Vinyl


Here is my greif...............

I am getting some major static electricity every time
I remove an LP from my Turntable platter.

Here is my setup:

The platter is a Teres coccabolo (hardwood)
& I get the static with or without using my Herbies way excellent turntable mat.

I installed a grounding conductor screwed to the brass
platter spindle & grounded it to the tubed preamp & no
change.

I also use a Mapleshade Ionoclast static buster on the vinyl just before dropping the stylus, & still the bloody
static is their when I pull the vinyl from the platter
after the LP has gone thru the grooves.

any thoughts? ? ? ? ?
socoaste
I tried dryer sheets, even placing smaller pieces on platter and they stick to the record as I pull it, I am a bit surprised I have such an issue with Vacuum hold down and clamp I thought that wouldnt be an issue.
viridian - good one...thank goodness voltage ain't amps or I'd be a crispy critter for sure. Static Guard comes in a spray can. You can buy it in the laundry section at the grocery store. My wife used it to de-static clothing (that's what they sell it for). I urged caution about inhalation toxicity.
Socoaste i feel your pain, i am having the very same problem, now that its good and hot down south the A/C is drying the house of humidity, a good thing for comfort but not so for vinyl pleasure, i think that a humidifier will be bucking the A/C. i remember a tip from john at summit audio, this item
ANTI-STATIC RECORD CLEANER DUST BUG TONEARM LINN SME
is available on ebay, as doug mentioned above it grounds the lp eliminates static, i am getting one today will let yall know how it works,
Okay I'm home from work.......Daaaaaaamn!
& I thought I was the only one!
Thanks for all the feedback.....

I forgot to mention That I also use a hunt brush, &
the floor is hardwood. Oh yeah..& the phonostage has an earth ground.

Okay.... That makes sense to me about my hardwood platter
is an insulator & therefore isn't directing static buildup
away from the platter.

Hey....Here's a thought...I am using a 1/2" tape drive
I got from Chris Brady, Mylar (or similar). Maybe I
could use a belt that has better conducting properties,
metal particles coated on the tape, Then install
a grounding conductor on the motor housing. (mine runs
on 12volts, so currently has no earth ground.

maybe one of those (expensive) carbon platter mats would help. probably, But I think they are +$200.00 Ouch.

Also.....I am now wondering if the problem is being
caused by an air purifier (ionizing type) that I have inside the room. Hmmmm. I think I will disconnect it
& see if anything improves.
I pretty much need air purifier since I live right next
to one of the most busiest freeways in so, Cal.
(hideous air quality) You should see the black toxins/grunge that the purifier pulls out of the air!!!
That is staying, Or I'll be heading to the grave!

Okay.....many of You mentioned an air purifier, Hey Great idea, I never even thought of that. It looks like I will
be experimenting here & see what I come of with.
I will check back later with any findings.
THANKS!!
Cripes, I goofed up on my last post, How can I
edit the post?
I was refering to the Air HUMIDIFIER that some of You
mentioned, But I wigged out & typ'od in air (purifier)
by mistake....DUH.