Static on Vinyl


Here is my greif...............

I am getting some major static electricity every time
I remove an LP from my Turntable platter.

Here is my setup:

The platter is a Teres coccabolo (hardwood)
& I get the static with or without using my Herbies way excellent turntable mat.

I installed a grounding conductor screwed to the brass
platter spindle & grounded it to the tubed preamp & no
change.

I also use a Mapleshade Ionoclast static buster on the vinyl just before dropping the stylus, & still the bloody
static is their when I pull the vinyl from the platter
after the LP has gone thru the grooves.

any thoughts? ? ? ? ?
socoaste
I am not familiar with Staticguard, but it would be simple for you to try it out. Will probably work. "Winter discharge issue", sounds ominous, maybe better to consult your physician or psychiatrist.
I tried dryer sheets, even placing smaller pieces on platter and they stick to the record as I pull it, I am a bit surprised I have such an issue with Vacuum hold down and clamp I thought that wouldnt be an issue.
viridian - good one...thank goodness voltage ain't amps or I'd be a crispy critter for sure. Static Guard comes in a spray can. You can buy it in the laundry section at the grocery store. My wife used it to de-static clothing (that's what they sell it for). I urged caution about inhalation toxicity.
Socoaste i feel your pain, i am having the very same problem, now that its good and hot down south the A/C is drying the house of humidity, a good thing for comfort but not so for vinyl pleasure, i think that a humidifier will be bucking the A/C. i remember a tip from john at summit audio, this item
ANTI-STATIC RECORD CLEANER DUST BUG TONEARM LINN SME
is available on ebay, as doug mentioned above it grounds the lp eliminates static, i am getting one today will let yall know how it works,
Okay I'm home from work.......Daaaaaaamn!
& I thought I was the only one!
Thanks for all the feedback.....

I forgot to mention That I also use a hunt brush, &
the floor is hardwood. Oh yeah..& the phonostage has an earth ground.

Okay.... That makes sense to me about my hardwood platter
is an insulator & therefore isn't directing static buildup
away from the platter.

Hey....Here's a thought...I am using a 1/2" tape drive
I got from Chris Brady, Mylar (or similar). Maybe I
could use a belt that has better conducting properties,
metal particles coated on the tape, Then install
a grounding conductor on the motor housing. (mine runs
on 12volts, so currently has no earth ground.

maybe one of those (expensive) carbon platter mats would help. probably, But I think they are +$200.00 Ouch.

Also.....I am now wondering if the problem is being
caused by an air purifier (ionizing type) that I have inside the room. Hmmmm. I think I will disconnect it
& see if anything improves.
I pretty much need air purifier since I live right next
to one of the most busiest freeways in so, Cal.
(hideous air quality) You should see the black toxins/grunge that the purifier pulls out of the air!!!
That is staying, Or I'll be heading to the grave!

Okay.....many of You mentioned an air purifier, Hey Great idea, I never even thought of that. It looks like I will
be experimenting here & see what I come of with.
I will check back later with any findings.
THANKS!!