Bryan, the bearing housing is not actually the mounting stub. The bearing housing is above the mounting stub, and the stub is just the connector that goes through the plinth. They are all one piece, but the upper part houses the bearing and the lower part is the mounting stub. Also, even though I don't want to turn my TT upside down right now, I think that the nut that holds the bearing mounting stub to the plinth is more than 1/8" on each side. It is a large nut with plenty of surface area to hold real tight. And the bearing housing shoulder that hugs the plinth on top is the 1 1/2" part that makes an excellent "clamping" arrangement for holding it to the plinth. No problems in that area.
As far as Redpoint's negative comments about the Teres, I say let the market be the judge. Also, notice that Chris was very objective in stating the reasons for his design decisions, and made no derogatory references toward Redpoint.
As far as Redpoint's negative comments about the Teres, I say let the market be the judge. Also, notice that Chris was very objective in stating the reasons for his design decisions, and made no derogatory references toward Redpoint.