Some good advice,some bad.I was a Harley wrench for a couple years till a shoulder went down.Lots of oils,greases etc. which is fine.Stay away from anti-seize[messy] and lock-tite[pointless].Petro-chemicals[WD-40,sewing machine oil,Vaseline etc.] are OK,but best to stick to teflon base[Tri-flow,Bel-ray etc.].They dont smell as bad and are superior for lube.Pam cooking spray[veg base] is an option as is Crisco as last resorts.When tightening screws use 2 fingers unless your units have a top-end of say 75MPH and vibrate alot in their racks.Never turn a screw or bolt without pushing in at the same time.Too much info for this thread but be gentle when tightening and use some form of lube would eliminate 95% of stripped heads on audio equipment.YMMV,Bob
ruined a phillips screw, any inspired solution?
Not strictly audio but related and a real mess. I wanted to open up the cabinet of a cdp to change a tube inside which involved removing 6 small phillips screws with a recessed head,... and of course, there is always one that pretends to be sword Excalibur. Sadly, after I had attacked it with every imaginable screwdriver, I noticed that I had literally milled out the head. So I now have an unbudgeable screw with a perfectly round cavity on the head sitting on a rather sensitive piece of gear (the plate I have to remove holds most of the electronic circuitry, the cd drive and the tube, go figure). Anyone faced a similar conundrum and solved it?
Thanks for not laughing 8^(
Thanks for not laughing 8^(
- ...
- 36 posts total
- 36 posts total