2. misc-audio
  3. 1242018455

Sound Insulation

I'm considering purchasing some material to mask some mechanical noise from a component in my rack.

I was considering 3/8" ultra-soft polyurethane (sorbothane) sheet, or perhaps some flexible polyimide, or flexible polyurethane (all sold at McMaster.com).

Other ideas?

Heat is not an issue. I only require about a 12"x12" piece.
tvad
tvad OP
9,467 posts
 
Received the 3A Link All Althorn Absorption Wads, and it works like a charm.

I think I'll use the extra sheets to line a couple component case interiors to provide some damping.
kenk168
175 posts
 
Hi Tvad,

Glad that the stuff works and quite easy on the wallet. Please update once you have a chance to do your audio component case interiors. I have a set for my computer case yet to be installed.

Regards,

Kenobi
newbee
4,093 posts
 
Tvad, If you are so inclined, after you try this stuff in the component cabinets could you comment on heat retenton which would normally be minimized by the component case acting as a heat sink? I'm curious -

Thanks
tvad OP
9,467 posts
 
Lining my cases with the absorption wads is low on my list of priorities. However, my intention was to mount smaller strips or squares of the material to act as vibration deadening rather than noise control. Therefore, I'd be using less of the product. I hadn't considered heat retention.
cyclonicman
693 posts
 
TVAD, Never tried it but 3M has these damping sheets that may help with your noise problem.

http://www.musicdirect.com/category/49?brandFilter=&sort=&genreFilter=&category_id=49&start=50
More to discover