Bel Canto evo's

Morasp,

I been looking for recomendations on PWR cords thanks
for mentioning. I was also told by someone to try the
Eichmann Xpress cords. They are what the BC guys are
running on their own sytems. Is the cap upgrade something
that is effective for EVO2 as well as the 200.2? I know
they did change the PS section for the EVO2-6.

Thanks...

The SLVR was my favorite out of a lot of highll regarded cords including palladium and elrod standard. It was the cheapest also. They all were very good however. I don't know about the evo2, when I auditioned it one of the allen screws was stripped and I couldn't look inside. I would think it would help as the solen and Auricap are only 100, 10, and 1 uF placed close to the TRIPATH module for current demands during fast transients and on the 200.2 at least all of the bulk capacitance was spaced quite a ways from the module. Any wiring between the capactiors and the module will have be inductive with an impedance that will cause the voltage to droop during transients.

Thanks...

I have not looked inside mine yet but i will. Sounds
like the caps are aranged in a pretty typical config
hopefully they are hitting the pwr plane at the 100 with
only surface connections thru the 10 & 1 after that to the module. I will take a look...

Thanks..

Sorry, I need to start proof reading my posts. The smaller solen and auricaps (100, 10, 1) were the ones that I added to the Evo. I purchased them from percy audio.