2. amps-preamps
  3. 1054711232

Amp heat sinks are ringing

I have been working to reduce the slap echo in my room by using quick hand claps, and various foam panels to attenuate the noise. I have discovered that my Classe CAM 200 monoblock heat sinks are actually ringing- they can be excited by handclaps, and heard across the room. There are 10 heat sinks per amp, about 2" deep by 8" high. Running my fingers along the heatsinks makes them ring like a bell!

I am concerned that this ringing might be excited when I am listening to the system, and may add extra treble noise.

Does anyone have any suggestions for damping out the noise? I am concerned about using a material that can withstand the heat, and not impede the airflow?

thanks for your help!
gnobber
blkadr
731 posts
 
A while back I read a review of the Belles 150 Hot Rod amp at soundstage.com in which they addressed heat sink vibration. Dont remember what they used, but you might check it out.
timo
610 posts
 
You may want to try placing some "felt-type" pads between the heatsinks on your amps. This should damp out some of the ringing and cost you next to nothing! However, there are probably better and more effective methods that may cost more.
zoya
119 posts
 
Gnobber, how hot do the heatsinks normally get? If they stay cool - than you can play with some damping material. But if they run hot, anything you place on or around heatsinks will impede cooling and can cause damage to the output devices. Perhups, placing the amp in the separate room and running the cables to the speakers through the wall may be an answer.
More to discover