Preamp input needed


Hi all,
I am in the market for a new/used amp. Pricerange ~2800.
I currently run Pass Aleph 0 mono blocks, a Denon DCD 16something, AMT Kithara speakers, Audible Illusions Modulus...
My car was broken into and the Modulus stolen. So I could get a new 3A (~2800).. or anything else in that price range

I narrowed it down to:
ACR LS16MKII
LS25MKII
Pass X1
Audible Illusions L2 or Modulus 3A
Tact RCS 2.0AA

Hmmm I really don't like overly analytic sound... no mush either. I really liked my old setup.... However the Pass X1 is mighty tempting... so is the TACT RCS....

Opinions please
mtiso
I'm using the PL X2.5 and really enjoy it. Supposedly it is quite similar to the X1. To help keep it from getting too analytical, you might try the following:

o Obviously, mate the X.1 with an amp that is this side of warm and rich in sound.
o Connect the pre to a quality-oriented line conditioner.
o Install Audio Points under all components, racks, and speakers.
o In my case, I have all my component's dedicated lines ungrounded to lower the noise-floor and dirty AC. But upon reconnecting the ground only for the preamp, an even lower noise-floor and a bit of silkiness was added to the presentation.

-IMO

I owned the TACT RCS and liked it at first, but eventually got dissatisfied.

*Just my opinion*, but the Tact should be purchased primarily for the room correction function and secondarily for the preamp function, not the other way around. For that sort of cash you could easily find a preamp that bests it. Once again, this was my experience with the unit, YMMV.
I think that if you're looking at the ARC line up, you can do better than the LS25 and LS16 for a little less money. Do a search on the ARC LS5 Mk III. The LS 5 Mk III's only competition in the ARC line-up is the REF 1 and 2. If you're not looking for analytical, the LS5 has that tube magic sound in spades over the LS25 and LS16. Something elese to consider. Good Luck.