1. Home
  2. analog
  3. 1433897303

Lyra Delos 'belly cover'

For a lack of a better description or name the 'U' shaped piece of material? / plastic? on the underside of my Lyra Delos cartridge is starting to fray. This cover is behind the boron whisker cantilever and covers the area where the 4 wires pass from the cart to the tonearm connector interface. So, the question is....I am debating removing this cover because it is starting to drag on my LP's. (other nude cartridges don't utilize the 'belly cover'.) Bad idea? Any thoughts on how to proceed in its removal? Thank You in Advance!!
quincy
viridian's avatar
viridian
4,184 posts
 
I was always under the impression that it was a type of washi paper. The purpose is as a dust sheild for the motor and suspension.

I imagine that it would be easy to cut away the free part and then scrape the balance off of the body. The trick is getting a new piece. You might just try speaking with Jonathan Carr at Lyra. He may just take care of the whole thing for you, or send you an appropriately sized piece of washi paper.

Good luck. It's always better to do lots of research on these types of things and have a clear direction before wading in.
quincy OP
176 posts
 
Thank you for your replies. I have sent an email to the Lyra web site on record. lyra@audioquest.com Hopefully I will receive an answer and will post their reply accordingly. (I'm sure I am not the only one with this question or issue).
actusreus
733 posts
 
I don't where you got your cart, but if it came with the manual, as it should, it clearly states it's washi paper, it's there for a reason, and it is NOT to be removed as removing it will void warranty.
mofimadness's avatar
mofimadness
4,152 posts
 
Quincy...you need to send Alasdair from Audioquest, (the
Lyra distributor) an email and tell him what is going on. He
will send all the info that you need to get this fixed.

Apatrick@audioquest.com
moonglum
605 posts
 
Dear Quincy....apologies in advance for such an obvious question but have you checked that the washi paper is frayed and not embellished with "white" lint?
When this happens (occasionally) with my Delos I usually just tear off a strip of kitchen roll and use the "hairy" edge to gently "comb" the lint off without disturbing the washi paper. A carbon fibre brush is too much of a lethal weapon! ;^)

If it is indeed frayed, were you getting feedback from the washi paper's contact with the disc surface during the fraying process?
If so, the reason should be investigated i.e. check VTF is within proscribed range then check the angle of the cantilever to front face is 90 degrees when actually playing an LP?
If you can achieve this and find you are still not getting surface clearance then VTA comes into question(?)
Hope this helps.
More to discover