1. Home
  2. amps-preamps
  3. 1115336329

Plinius 9200 Driving Magnepan 3.6Rs

Hi .. I am fairly new to this site, however I do have a question that is on my mind. I own a Plinius 9200 Integrated Amp ... and am auditioning a pair of Magnepan 3.6R speakers. My question/concern ... when driven to acceptable volumes (volume control to around 11 o'clock or slightly greater) how hot should I expect this amplifier to run with the Maggie's load? It would seem to me that it's rather hot after about 30 minute's use, but I have no reference to compare it to. Should I choose more efficient speakers with a higher impedance?? Or is the Plinius a normally hot running amp. It is located in a well ventilated in an open rack. Any comments/advice would be much appreciated!!
rfstock
konghh
12 posts
 
Hi. I had a Plinius 8200mk1 and was using it with the 1.6QR. I have a large room (20x21x9) made even "larger" with opening to one side and it's very taxing for the amp. The 8200 doesn't have enough power so even if your 9200 is more powerful, I serioiuly doubt you could drive the 3.6 well at all. IMO, you either keep the 1.6QR with 9200 or get a bigger amp with 3.6.

As for volume pot location not an indication of how hard you are pushing the amp but use clipping as an indication instead. I got similar answer from Plinius (but did say 1-2 o'clock is o.k.) and from Krell (my present 400xi and had tried 110 out of 150 digital volume).
My 2 cts.
macdadtexas
1,794 posts
 
Plinius is not the answer for Maggies. Just not a good match. Try Parasound JC-1 monoblocks, or any of the Bryston amps that produce more than 400W at 4ohms. But the big bad boys your really want are Innersound. Read some reviews, you will realize they are mades SPECIFICALLY to drive this type of difficult load. No heat from the amp as well. Mono 800's, or the ESL 300's great amps.

Good luck
macdadtexas
1,794 posts
 
Sorry, Krell's as well, can't leave them out. McIntosh's do not match. Even the 500W boys. I don't know what, but they never sounded right to me.
konghh
12 posts
 
Hi Mac, have you tried and compared the Krell (specifically the 400xi) and the Innersound ESL300? If yes, would very much like to hear your comment esp. the midrange. Thanks.
gdecent33
19 posts
 
RFstock,I wanted to know what was the sound quality of the Plinius and the 1.6
More to discover