Ok Bufus;
They make copies.
Process: Very tiny plastic granulate is poured into an "oven", there it is melted, poured onto a small platter and just before the plastic sets again a "master-copy" is pressed ( mirrored ) over the platter. Takes about 2secs, and then the plastic has the master-copy´s "grooves" in it ( to small to see with eye ). The "almost-cd" then is lifted out and a thin aluminum foil is placed over the "top" of the unfinished cd ( for laser to be reflected in, just like a mirror ). After that a "empty" platter of plastic is glued onto the "bottom" of the cd, protecting the "grooves". Finally a thin layer of laquer or print is placed on top of the cd. Thus the "top" of the cd is the most vunerable part of the disc. The "music" side is protected by a 1mm plastic layer.
Each time a press is done over the melted plastic, it WILL damage the master-copy. However the damage is minute, but after 20000presses you would have lost 5-10% of the original state. Not much - but as guessed, very audible.
Mike
They make copies.
Process: Very tiny plastic granulate is poured into an "oven", there it is melted, poured onto a small platter and just before the plastic sets again a "master-copy" is pressed ( mirrored ) over the platter. Takes about 2secs, and then the plastic has the master-copy´s "grooves" in it ( to small to see with eye ). The "almost-cd" then is lifted out and a thin aluminum foil is placed over the "top" of the unfinished cd ( for laser to be reflected in, just like a mirror ). After that a "empty" platter of plastic is glued onto the "bottom" of the cd, protecting the "grooves". Finally a thin layer of laquer or print is placed on top of the cd. Thus the "top" of the cd is the most vunerable part of the disc. The "music" side is protected by a 1mm plastic layer.
Each time a press is done over the melted plastic, it WILL damage the master-copy. However the damage is minute, but after 20000presses you would have lost 5-10% of the original state. Not much - but as guessed, very audible.
Mike

