OCMs are working well (3 of the 4 are bridged and 1 is stereo).
One of yours is on the rear right channel (B&W Nautilus 804) and the other is on the center (Nautilus HTM1).
I kept the 2 that seemed to be the same age together on the rears.
My original OCM200 runs the other rear N804 and I use the Soloist 200 for the sides (stereo / B&W SCM-8 dipoles).
I have not purchased the 2nd 350A monoblock / converted my 350A to a monoblock yet .... actual reason for my questions was to prepare for their arrival in March or April.
The fronts (eventually two mono block 350As vs 1 stereo) are N802's and I am hoping for great things when I get the power situation sorted out.... Then it the "big screen" (using a 42" now and it is hard to get really absorbed into the film ... although the sound can be awesone.)
As the volume across all channels goes up I think (I can't measure it - only observe it) that I am running out of current (not as dynamic as I would expect) .... you would think the volume level would be ear shattering but it is not.... I don't really want it loud just very dynamic, Open / Clear / Musical .... at low level it is just that.
Couple of other things are expected to improve the sound ... the Anthem AVM-20 will get an upgrade at the factory to 2.0 SW & Firmware and the Belles 20A preamp is being upgraded by David B. to improve its sound as well (new volume pot / some circuit/component mods) ... have not experimented with tubes yet.
From all of the feedback, the circuit upgrades will probably yield the biggest bang for the buck. Not that familiar with other conditioners ... keep getting mixed signals about using / not using.
The single largest concern I have is the possible amp damage and using 2 conductor wire (Belden 83802) to boxes without grounds ... but I may not fully understand the wiring plan ... separate dedicated grounds can easily be accomodated to meet code.
