Wilson MAXX musicallity and sound


I am missing the liquid and icy sound of high end audio with the following expensive combination . How can I improve achieve that dream sound:
Wilson MAXX 1, Accuphase A50 V power amp,Air tight ATM 211 single ended mono amp, air tight ATC 2 pre and Accuphase DP80L/DC81L cd/converter with Transparent referecne speaker cable and Accuphase DG38 room correction /equalizer. It is quite an expensive system but lacks that liquid sound of high end and bass extension. Please share your opinion how to improve it.Thanks
fpooyandeh
Maybe you should throw a little bit more money at the problem. J/k. :)

This is almost certainly an issue with your room. I would call a professional consultant or at the very least check out the room acoustics circle at audiocircle.com

-Rob
WIlson speakers are extremely sensitive to room set-up; especially considering the modular design used for time-alignment that the Maxx's incorporate. You might want to have your dealer come back out to re-position the speakers using the Wilson Audio Setup Procedure (WASP). You have some amazing equipment which should have plenty of potential for what you are searching for. Good luck.
Please post a picture of your room, also post measurements and placements of room treatments.
I am missing the liquid and icy sound of high end audio with the following expensive combination . How can I improve achieve that dream sound?

Of course you are. This system is pretty much SOTA. It won't give you warm sloppy bass or icy sound. In short not boom boom tizz. The midrange will be quite forward compared to other speakers (not because it is - but because it is flat where most normally dip).

However, your amplification looks woefully underpowered for the speakers - they dip to nearly 2 Ohm - an extremely difficult load - so you may need something with high current capability like a Krell.

If the sound is claustrophobic (lacks air or spaciousness = is that what you mean by "liquid") then it may be a grill or a placement issue. The chunky way this speaker is built will inevitably mean that you get odd grill effects and some additional edge diffraction compared to other speakers - depending on your listening position/placement this may be more or less intrusive. (For example, the support structure for the midrange tweeter module may have an influence and you might try some foam padding there to see if it might be affecting the sound. Also check the manual to see if thois uis supposed to be used with grill on or grill off....I suspect the grill will make a juge difference.)
No matter how great the speaker and electronics, the speaker must be properly placed in the room. Given the weight and size, these babies are often just "plopped" into an approximately good position and left to disappoint the owner forever.

IMHO, you should beg and pay a Sumiko dealer to come out and do a Sumiko Master Set for you. Don't change any equipment until you do this. You can't judge a system until the speakers are properly set. In the few Wilson systems that I've heard, this is a chronic problem, with great speakers not reaching near their potential due to lackluster placement.

See my review of the Sumiko Master Set and Guidocorona's comments regarding the Master Set of his system for more in-depth discussion.

Dave